Siemens 2614 manual SpeedStream

Page 7

These ports can auto-negotiate the operating speed to 10/100 Mbps, the mode to half/full duplex, and the pin signals to MDI/MDI-X, allowing these ports to be connected to any network device with straight- through cable. The ports can be connected directly to a computer or to a server equipped with an Ethernet network interface card, or to a networking device such as an Ethernet hub or switch.

(1) RJ-45 WAN port for connection to an xDSL or cable modem. This port is fixed at 10 Mbps full- duplex and only supports MDI-X pin signals. Consequently, you will have to use either a straight- through or crossover cable, depending on the port type used with the modem.

 

Figure 2-1. SpeedStream 2614

 

 

Item

Description

 

 

Reset Button

Resets the power and restores the default factory settings.

 

 

LEDs

Power, WAN and LAN port status indicators.

 

 

LAN Ports

Fast Ethernet ports (RJ-45). Connect devices on your local area network to these ports

 

(such as a computer, hub or switch).

 

 

Printer Port

Parallel port (25-pins, D-type, female) to connect a shared printer.

 

 

WAN Port

WAN port (RJ-45) to connect your xDSL/cable modem or Ethernet router.

 

 

COM Port

Serial port (9-pins, D-type, male) to connect your ISDN TA or 56K analog modem.

 

 

Power Inlet

Connector for the included power adapter.

 

Caution: The included power adapter is DC 5V/2.4A. Using the wrong type of power

 

adapter may cause damage.

 

 

 

Table 2-1. SpeedStream 2614 Components

2-2

Image 7
Contents 2614 Table of Contents Appendixes Introduction Features and BenefitsAbout the SpeedStream Applications Package Contents Installing the SpeedstreamDescription of Hardware SpeedStream Before Starting Hardware InstallationInstallation Procedure System RequirementsConnecting the SpeedStream LED Status Indicators Page Web Browser Management Interface Configuring the SpeedstreamNavigating the Management Interface Menu Item Description Menu SelectionsGeneral box, select Temporary Internet Files Configuration ChangesView Network and Device Status On the Tools menu, click Internet OptionsSet the Time Zone Simple Setup ProceduresSet or Change a Password On the Simple Setup menu, click Change PasswordOn the Simple Setup menu, click Set Time Zone Configure the WAN ConnectionStatic IP Address Fixed IP Fill in the relevant fields under Secondary Dial-up Configure LAN Gateway and Dhcp Settings Advanced Setup ProceduresEnable Virtual Server Enable Firewall ProtectionNetwork Address Translation NAT Configure Special ApplicationsConfigure Client Filtering Configure Miscellaneous FeaturesSystem Tools On the Tools menu, click Change PasswordBackup Settings Reset RouterRestore Factory Defaults Update FirmwareInstall the TCP/IP Protocol Installing and Configuring TCP/IPClick Start/Settings then click Control Panel Dynamic IP Allocation via a Dhcp Server Configure TCP/IP for the SpeedStreamTCP/IP Verification Manual IP ConfigurationIs TCP/IP properly configured on your computer? Install the Print Server Program Configuring Printer ServicesSpecified location Select Port Name Windows 95/98/NT/ME Configure the Printer PortSelect Printer Port WindowsSelect Local printer then click Next 11. Select Printer Port Unix SystemsAppendix a TroubleshootingTechnical Support Ethernet Cable Cable Types and SpecificationsAppendix B CablesSerial Port Pin Assignments RJ-45 Pin AssignmentsRJ-45 Pin Numbering Serial Port to 9-Pin COM Port on Computer DB-9 Port Pin AssignmentsSerial Port to 25-Pin DCE Port on Modem Serial Port to 25-Pin DTE Port on Computer Printer Port Pin AssignmentsDB-25 Printer Port Pin Assignments Pin Signal Name DirectionSpecifications Temperature