Toshiba TDP-S8 owner manual Parts on the rear panel

Page 18

Parts on the rear panel

1	2	3	4	5	6
( )	( )	( ) ( ) ( ) ( )

		8	7
		( ) ( )
	Name	: Main Function
(1)	MONITOR terminal	: Connect to a computer display, etc.
(2)	COMPUTER IN terminal	: Input analog RGB signal from a computer or other
		source, or a component video signal (Y/PB/PR) from
		video equipment.
(3)	S-VIDEO terminal	: Input S video signals from video equipment.
(4)	VIDEO terminal	: Input video signals from video equipment.
(5)	AUDIO IN terminal	: Input audio signals.
(6)	CONTROL terminal	RS232C :When operating the projector via a computer,
		RS232C :When operating the projector via a computer,
		connect this to the controlling computer’s RS-232C
		port. p.44
(7)	AUDIO OUT terminal	: Outputs audio signals.
(8)	Antitheft lock hole	: Attach a safety cable or any other antitheft device.

Image 18

Contents Data Projector TDP-S8 Safety Precautions USA onlyBefore Using Important Safety Instructions Power Sources VentilationSource of Light Heat Power-Cord ProtectionCleaning Water and MoistureObject and Liquid Entry Lightning stormsDo not place the product vertically Stack InhibitedAccessories Damage Requiring ServiceServicing Safety Check Important Safety InstructionsReplacement Parts Do not use the product in a closed installation statePlace and Manner of Installation Power Supply Cord SelectionImportant Precautions Save Original Packing MaterialsImportant Precautions Exemption ClausesAvoid Volatile Liquid Disposal Other Cautions and InformationsCopyrights TrademarksRemote Control Batteries Contents Page Checking the package contents Names of each part on the main unit Names of each part on the control panel and remote control Parts on the rear panel Preparing and using the remote control Loading dry-cell batteries Into the remote controlOperating the remote control Placement Placement StylesFloor-mounted front projection As seen from the side Projection Distance and SizeConnection Before connectionTurning the power on and off Turning the power on Press the ON/STANDBY buttonTurning the power off Press the ON/STANDBY button Press the ON/STANDBY button againBasic operations Turn on the powerSelect the language When using the ﬁrst time Activate the connected device To adjust the horizontal angle, use Tilt adjuster Projector placement angle adjustmentsAdjusting the screen size and focus To stow the foot adjuster, hold up the projectorPress the remote control’s Auto SET button Using handy featuresUsing auto setting Only for analog input from computer Correcting the keystone distortionFreezing the image Freeze Password functionCutting off the picture and sound temporarily Mute Key LockUsing handy features If you forgot the password, please inquire your dealerRe-enter the same password for conﬁrmation Using the menus How to use the menusImage adjustment menu Display setting menu Detailed description Screen sizeBackground Detailed description Fan mode Using the menusDefault setting menu Lamp powerDisplaying Information Status display B/P RLamp replacement When the lamp is brokenAbout lamp Lamp replacement Reset the lamp timer Used LampsLens and main unit cleaning Lens cleaningMain unit cleaning Trouble indications No powerPower went out during use Lamp went out during use, or won’t come onBefore calling service personnel Separately sold product SpeciﬁcationsList of general speciﬁcations SpeciﬁcationList of supported signals RGB signals SpeciﬁcationsList of supported signals Y/PB/PR signals List of supported signals Video, S-Video signalsPin assignment of Computer in & Monitor terminals Control terminal Pin assignment