Toshiba TDP-S8 owner manual Displaying Information Status display, B/P R

Page 34

Using the menus (Continued)

■Displaying Information (Status display)

This displays information about the input signal,lamp use time,etc.

“Yes”: displayed, “No”: not displayed

	Item	Description	Computer	Y/PB/PR	Video	S-video
	Input	Input source name	Yes	Yes	Yes	Yes
	Resolution	Resolution (in dots)	Yes	No	No	No
	Video mode	Color method of video signal	No	Yes	Yes	Yes
	Picture mode	A group of Pre-set display mode	Yes	Yes	Yes	Yes
	Lamp time	Time of lamp use [Note 3]	Yes	Yes	Yes	Yes
	Version	Firmware version [Note 4]	Yes	Yes	Yes	Yes

Notes

1:The mode of supported RGB signals p.42 is shown.

2:Sync signal polarity shown as P (positive) or N (negative) for [H/V].

3:Displays [Lamp time] as a measure of when the lamp should be replaced. (Cannot be used as a counter of guaranteed lamp time.) When the displayed time approaches 2,000 hours, consult with a store about getting a TLPLV6 replacement lamp (sold separately) prepared.

4:[Version] shows the version of the projector’s internal control program. This version is referred to for customer service, etc.

34

Image 34

Contents Data Projector TDP-S8 Safety Precautions USA onlyBefore Using Power Sources Ventilation Important Safety InstructionsSource of Light Heat Power-Cord ProtectionCleaning Water and MoistureObject and Liquid Entry Lightning stormsDo not place the product vertically Stack InhibitedDamage Requiring Service AccessoriesServicing Safety Check Important Safety InstructionsReplacement Parts Do not use the product in a closed installation statePlace and Manner of Installation Power Supply Cord SelectionImportant Precautions Save Original Packing MaterialsExemption Clauses Important PrecautionsAvoid Volatile Liquid Disposal Other Cautions and InformationsCopyrights TrademarksRemote Control Batteries Contents Page Checking the package contents Names of each part on the main unit Names of each part on the control panel and remote control Parts on the rear panel Loading dry-cell batteries Into the remote control Preparing and using the remote controlOperating the remote control Placement Styles PlacementFloor-mounted front projection As seen from the side Projection Distance and SizeConnection Before connectionTurning the power on and off Turning the power on Press the ON/STANDBY buttonTurning the power off Press the ON/STANDBY button Press the ON/STANDBY button againBasic operations Turn on the powerSelect the language When using the ﬁrst time Activate the connected device To adjust the horizontal angle, use Tilt adjuster Projector placement angle adjustmentsAdjusting the screen size and focus To stow the foot adjuster, hold up the projectorPress the remote control’s Auto SET button Using handy featuresUsing auto setting Only for analog input from computer Correcting the keystone distortionFreezing the image Freeze Password functionCutting off the picture and sound temporarily Mute Key LockIf you forgot the password, please inquire your dealer Using handy featuresRe-enter the same password for conﬁrmation Using the menus How to use the menusImage adjustment menu Detailed description Screen size Display setting menuBackground Detailed description Fan mode Using the menusDefault setting menu Lamp powerDisplaying Information Status display B/P RWhen the lamp is broken Lamp replacementAbout lamp Lamp replacement Reset the lamp timer Used LampsLens cleaning Lens and main unit cleaningMain unit cleaning Trouble indications No powerPower went out during use Lamp went out during use, or won’t come onBefore calling service personnel Separately sold product SpeciﬁcationsList of general speciﬁcations SpeciﬁcationList of supported signals RGB signals SpeciﬁcationsList of supported signals Video, S-Video signals List of supported signals Y/PB/PR signalsPin assignment of Computer in & Monitor terminals Control terminal Pin assignment