Toshiba TDP-S8 owner manual Turning the power off Press the ON/STANDBY button

Page 24

■ Turning the power off

1 Press the ON/STANDBY button.

A message appears on the screen, conﬁrming that you wish to shut off the power. This message will disappear after a moment. (This operation is no longer valid after the message disappears.)

2Press the ON/STANDBY button again.

The screen turns off, but the internal cooling fan continues to operate for a short. Then , the projector goes into standby mode.

When cooling lamp

POWER

FLASH

A

After cooling complete

POWER

B

ADuring cooling ,the POWER indicator ﬂashes.In this state,the power cannot be turned back on.

If you are in a hurry, there is no problem with unplugging the power cord or turn- ing off the main power switch in this state.

BIn standby mode

Note

•The projector consumes about 15W of power in standby. We recommend that you unplug the power cord if you will not be using the projector for an extended period.

PRECAUTION

•If the power cord is unplugged before cooling is complete, give the lamp time (about 5 minutes) to cool before plugging it back in.

24

Image 24

Contents Data Projector TDP-S8 Safety Precautions USA onlyBefore Using Important Safety Instructions Power Sources VentilationSource of Light Power-Cord Protection CleaningHeat Water and MoistureLightning storms Do not place the product verticallyObject and Liquid Entry Stack InhibitedAccessories Damage Requiring ServiceServicing Important Safety Instructions Replacement PartsSafety Check Do not use the product in a closed installation statePower Supply Cord Selection Important PrecautionsPlace and Manner of Installation Save Original Packing MaterialsImportant Precautions Exemption ClausesAvoid Volatile Liquid Other Cautions and Informations CopyrightsDisposal TrademarksRemote Control Batteries Contents Page Checking the package contents Names of each part on the main unit Names of each part on the control panel and remote control Parts on the rear panel Preparing and using the remote control Loading dry-cell batteries Into the remote controlOperating the remote control Placement Placement StylesFloor-mounted front projection As seen from the side Projection Distance and SizeConnection Before connectionTurning the power on and off Turning the power on Press the ON/STANDBY buttonTurning the power off Press the ON/STANDBY button Press the ON/STANDBY button againTurn on the power Select the language When using the ﬁrst timeBasic operations Activate the connected deviceProjector placement angle adjustments Adjusting the screen size and focus To adjust the horizontal angle, use Tilt adjuster To stow the foot adjuster, hold up the projectorUsing handy features Using auto setting Only for analog input from computerPress the remote control’s Auto SET button Correcting the keystone distortionPassword function Cutting off the picture and sound temporarily MuteFreezing the image Freeze Key LockUsing handy features If you forgot the password, please inquire your dealerRe-enter the same password for conﬁrmation Using the menus How to use the menusImage adjustment menu Display setting menu Detailed description Screen sizeBackground Using the menus Default setting menuDetailed description Fan mode Lamp powerDisplaying Information Status display B/P RLamp replacement When the lamp is brokenAbout lamp Lamp replacement Reset the lamp timer Used LampsLens and main unit cleaning Lens cleaningMain unit cleaning No power Power went out during useTrouble indications Lamp went out during use, or won’t come onBefore calling service personnel Speciﬁcations List of general speciﬁcationsSeparately sold product SpeciﬁcationList of supported signals RGB signals SpeciﬁcationsList of supported signals Y/PB/PR signals List of supported signals Video, S-Video signalsPin assignment of Computer in & Monitor terminals Control terminal Pin assignment