Toshiba TDP-S8 owner manual Placement Styles, Floor-mounted front projection

Page 20

Placement

Placement Styles

As shown in the ﬁgures below, this device can be placed in 4 different styles.

The factory setting is “ﬂoor-mounted front projection.” Set the [Projection mode] in the Default setting menu p.33 , in accordance with your needs.

Floor-mounted front projection

Floor-mounted rear projection

Ceiling-mounted front projection

Ceiling-mounted rear projection

WARNING

•Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing the unit. Attempting to clean/replace the lamp at a high site by yourself may cause you to drop down, thus resulting in injury.

•If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so. Mounting the projector on a ceiling requires special ceiling brackets (sold separately) and specialized knowledge. Improper mounting could cause the projector to fall, resulting in an accident.

•If the projector is ceiling-mounted, install the breaker for turning off the power in case of anomaly. Let everyone involved with the use of the projector know that fact.

20

Image 20

Contents Data Projector TDP-S8 Safety Precautions USA onlyBefore Using Source of Light Important Safety InstructionsPower Sources Ventilation Power-Cord Protection CleaningHeat Water and MoistureLightning storms Do not place the product verticallyObject and Liquid Entry Stack InhibitedServicing AccessoriesDamage Requiring Service Important Safety Instructions Replacement PartsSafety Check Do not use the product in a closed installation statePower Supply Cord Selection Important PrecautionsPlace and Manner of Installation Save Original Packing MaterialsAvoid Volatile Liquid Important PrecautionsExemption Clauses Other Cautions and Informations CopyrightsDisposal TrademarksRemote Control Batteries Contents Page Checking the package contents Names of each part on the main unit Names of each part on the control panel and remote control Parts on the rear panel Operating the remote control Preparing and using the remote controlLoading dry-cell batteries Into the remote control Floor-mounted front projection PlacementPlacement Styles As seen from the side Projection Distance and SizeConnection Before connectionTurning the power on and off Turning the power on Press the ON/STANDBY buttonTurning the power off Press the ON/STANDBY button Press the ON/STANDBY button againTurn on the power Select the language When using the ﬁrst timeBasic operations Activate the connected deviceProjector placement angle adjustments Adjusting the screen size and focus To adjust the horizontal angle, use Tilt adjuster To stow the foot adjuster, hold up the projectorUsing handy features Using auto setting Only for analog input from computerPress the remote control’s Auto SET button Correcting the keystone distortionPassword function Cutting off the picture and sound temporarily MuteFreezing the image Freeze Key LockRe-enter the same password for conﬁrmation Using handy featuresIf you forgot the password, please inquire your dealer Using the menus How to use the menusImage adjustment menu Background Display setting menuDetailed description Screen size Using the menus Default setting menuDetailed description Fan mode Lamp powerDisplaying Information Status display B/P RAbout lamp Lamp replacementWhen the lamp is broken Lamp replacement Reset the lamp timer Used LampsMain unit cleaning Lens and main unit cleaningLens cleaning No power Power went out during useTrouble indications Lamp went out during use, or won’t come onBefore calling service personnel Speciﬁcations List of general speciﬁcationsSeparately sold product SpeciﬁcationList of supported signals RGB signals SpeciﬁcationsPin assignment of Computer in & Monitor terminals List of supported signals Y/PB/PR signalsList of supported signals Video, S-Video signals Control terminal Pin assignment