Toshiba TDP-S8 owner manual Safety Precautions, USA only

Page 2

SAFETY PRECAUTIONS

The lightning flash with arrowhead symbol, within an equilateral triangle, is in- tended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EX- POSE THIS APPLIANCE TO RAIN OR MOISTURE. DANGEROUS HIGH VOLTAGES ARE PRESENT INSIDE THE ENCLOSURE. DO NOT OPEN THE CABINET. REFER SERVICING TO QUALIFIED PERSONNEL ONLY.

WARNING: USA only

Handling the cord on this product or cords associated with accessories sold with this product, will expose you to lead, a chemical known to the State of California to cause birth defects or other reproductive harm. Wash hands af- ter handling.

WARNING: USA only

This [product] contains mercury. Disposal of mercury may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronic Industries Alliance: www.eiae. org.

MODEL NAME: TDP-S8

USA only

TRADE NAME: DATA PROJECTOR

MODEL NAME: TDP-S8

Tested To Comply

 

With FCC Standards

 

FOR HOME OR OFFICE USE

 

FCC NOTICE: This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment gener- ates, uses and can radiate radio frequency energy and, if not installed and used in ac- cordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

2

Page 1 Page 3
Image 2
Page 1 Page 3
Contents Data Projector TDP-S8 Safety Precautions USA onlyBefore Using Source of Light Important Safety InstructionsPower Sources Ventilation Heat Power-Cord ProtectionCleaning Water and MoistureObject and Liquid Entry Lightning stormsDo not place the product vertically Stack InhibitedServicing AccessoriesDamage Requiring Service Safety Check Important Safety InstructionsReplacement Parts Do not use the product in a closed installation statePlace and Manner of Installation Power Supply Cord SelectionImportant Precautions Save Original Packing MaterialsAvoid Volatile Liquid Important PrecautionsExemption Clauses Disposal Other Cautions and InformationsCopyrights TrademarksRemote Control Batteries Contents Page Checking the package contents Names of each part on the main unit Names of each part on the control panel and remote control Parts on the rear panel Operating the remote control Preparing and using the remote controlLoading dry-cell batteries Into the remote control Floor-mounted front projection PlacementPlacement Styles As seen from the side Projection Distance and SizeConnection Before connectionTurning the power on and off Turning the power on Press the ON/STANDBY buttonTurning the power off Press the ON/STANDBY button Press the ON/STANDBY button againBasic operations Turn on the powerSelect the language When using the first time Activate the connected device To adjust the horizontal angle, use Tilt adjuster Projector placement angle adjustmentsAdjusting the screen size and focus To stow the foot adjuster, hold up the projectorPress the remote control’s Auto SET button Using handy featuresUsing auto setting Only for analog input from computer Correcting the keystone distortionFreezing the image Freeze Password functionCutting off the picture and sound temporarily Mute Key LockRe-enter the same password for confirmation Using handy featuresIf you forgot the password, please inquire your dealer Using the menus How to use the menusImage adjustment menu Background Display setting menuDetailed description Screen size Detailed description Fan mode Using the menusDefault setting menu Lamp powerDisplaying Information Status display B/P RAbout lamp Lamp replacementWhen the lamp is broken Lamp replacement Reset the lamp timer Used LampsMain unit cleaning Lens and main unit cleaningLens cleaning Trouble indications No powerPower went out during use Lamp went out during use, or won’t come onBefore calling service personnel Separately sold product SpecificationsList of general specifications SpecificationList of supported signals RGB signals SpecificationsPin assignment of Computer in & Monitor terminals List of supported signals Y/PB/PR signalsList of supported signals Video, S-Video signals Control terminal Pin assignment
Top Page Image Contents