Toshiba TDP-T9 owner manual Turning the power off Press the ON/STANDBY button

Page 26

■ Turning the power off

1 Press the ON/STANDBY button.

A message appears on the screen, conﬁrming that you wish to shut off the power. This message will disappear after a moment. (This operation is no longer valid after the message disappears.)

2Press the ON/STANDBY button again.

The screen turns off, but the internal cooling fan continues to operate for a short. Then , the projector goes into standby mode.

When cooling lamp

POWER

FLASH

A

After cooling complete

POWER

B

ADuring cooling, the Power indicator ﬂashes. In this state, the power cannot be turned back on.

If you are in a hurry, there is no problem with unplugging the power cord or turn- ing off the main power switch in this state.

BIn standby mode

Note

•The projector consumes about 15W of power in standby. We recommend that you unplug the power cord if you will not be using the projector for an extended period.

PRECAUTION

•If the power cord is unplugged before cooling is complete, give the lamp time (about 5 minutes) to cool before plugging it back in.

26

Image 26

Contents Data Projector TDP-T9 Safety Precautions USA onlyBefore Using Source of Light Important Safety InstructionsPower Sources Ventilation Heat Power-Cord ProtectionCleaning Water and MoistureObject and Liquid Entry Lightning stormsDo not place the product vertically Stack InhibitedServicing AccessoriesDamage Requiring Service Safety Check Important Safety InstructionsReplacement Parts Do not use the product in a closed installation statePlace and Manner of Installation Power Supply Cord SelectionImportant Precautions Save Original Packing MaterialsAvoid Volatile Liquid Important PrecautionsExemption Clauses Disposal Other Cautions and InformationsCopyrights TrademarksRemote Control Batteries Contents Page Checking the package contents Names of each part on the main unit Names of each part on the control panel and remote control Label locations Parts on the rear panel Operating the remote control Preparing and using the remote controlLoading dry-cell batteries Into the remote control  Remove the battery cover  Insert the dry-cell batteriesConnecting a computer Operating a computerFloor-mounted front projection PlacementPlacement Styles Projection Distance and Size Screen As seen from above As seen from the sideConnection Before connectionTurning the power on and off Turning the power on Press the ON/STANDBY buttonTurning the power off Press the ON/STANDBY button Press the ON/STANDBY button againBasic operations Turn on the powerSelect the language When using the ﬁrst time Activate the connected device To adjust the horizontal angle, use Tilt adjuster Projector placement angle adjustmentsAdjusting the screen size and focus To stow the foot adjuster, hold up the projectorPress the remote control’s Auto SET button Using handy featuresUsing auto setting Only for analog input from computer Correcting the keystone distortionFreezing the image Freeze Password functionCutting off the picture and sound temporarily Mute Key LockRe-enter the same password for conﬁrmation Using handy featuresIf you forgot the password, please inquire your dealer Using the menus How to use the menusImage adjustment menu Background Display setting menuDetailed description Screen size Detailed description Fan mode Using the menusDefault setting menu Lamp powerDisplaying Information Status display B/P RAbout lamp Lamp replacementWhen the lamp is broken Lamp replacement Reset the lamp timer Used LampsMain unit cleaning Lens and main unit cleaningLens cleaning Trouble indications No powerPower went out during use Lamp went out during use, or won’t come onBefore calling service personnel Separately sold product SpeciﬁcationsList of general speciﬁcations SpeciﬁcationList of supported signals RGB signals SpeciﬁcationsPin assignment of Computer in & Monitor terminals List of supported signals Y/PB/PR signalsList of supported signals Video, S-Video signals Control terminal Pin assignmentOthers