Toshiba TDP-T9 owner manual Lamp replacement

Page 38

Lamp replacement (Continued)

1Unplug power cord.

2Wait until lamp is sufficiently cooled.

Wait for at least 1 hour.

3 Remove the lamp cover.

3

Lamp cover

Loosen the two screws, raise the outer lamp

 

1

cover with your fingers as shown to remove

 

 

 

the outer lamp cover. Use care to avoid any

 

 

damage to nails and/or tip of your finger(s). If

 

 

you have any difficulty in removal, you can use

 

 

a screwdriver or any other smaller tool for your

 

 

convenience.

 

 

4Pull out the lamp.

Loosen the two lamp locking screws, pull up the handle to remove the lamp.

5Mount the new lamp.

Align the orientation, press down the new lamp until the bottom is reached, and lock in place using the two lamp locking screws.

6Replace the lamp cover.

Align the cover, and press it in, then tighten the screws loosened in step 3 until the lamp cover is no longer loose.

4

5

1

2

2

1

38

Page 37 Page 39
Image 38
Page 37 Page 39
Contents Data Projector TDP-T9 Safety Precautions USA onlyBefore Using Source of Light Important Safety InstructionsPower Sources Ventilation Heat Power-Cord ProtectionCleaning Water and MoistureObject and Liquid Entry Lightning stormsDo not place the product vertically Stack InhibitedServicing AccessoriesDamage Requiring Service Safety Check Important Safety InstructionsReplacement Parts Do not use the product in a closed installation statePlace and Manner of Installation Power Supply Cord SelectionImportant Precautions Save Original Packing MaterialsAvoid Volatile Liquid Important PrecautionsExemption Clauses Disposal Other Cautions and InformationsCopyrights TrademarksRemote Control Batteries Contents Page Checking the package contents Names of each part on the main unit Names of each part on the control panel and remote control Label locations Parts on the rear panel Operating the remote control Preparing and using the remote controlLoading dry-cell batteries Into the remote control  Remove the battery cover  Insert the dry-cell batteriesConnecting a computer Operating a computerFloor-mounted front projection PlacementPlacement Styles Projection Distance and Size Screen As seen from above As seen from the sideConnection Before connectionTurning the power on and off Turning the power on Press the ON/STANDBY buttonTurning the power off Press the ON/STANDBY button Press the ON/STANDBY button againBasic operations Turn on the powerSelect the language When using the first time Activate the connected device To adjust the horizontal angle, use Tilt adjuster Projector placement angle adjustmentsAdjusting the screen size and focus To stow the foot adjuster, hold up the projectorPress the remote control’s Auto SET button Using handy featuresUsing auto setting Only for analog input from computer Correcting the keystone distortionFreezing the image Freeze Password functionCutting off the picture and sound temporarily Mute Key LockRe-enter the same password for confirmation Using handy featuresIf you forgot the password, please inquire your dealer Using the menus How to use the menusImage adjustment menu Background Display setting menuDetailed description Screen size Detailed description Fan mode Using the menusDefault setting menu Lamp powerDisplaying Information Status display B/P RAbout lamp Lamp replacementWhen the lamp is broken Lamp replacement Reset the lamp timer Used LampsMain unit cleaning Lens and main unit cleaningLens cleaning Trouble indications No powerPower went out during use Lamp went out during use, or won’t come onBefore calling service personnel Separately sold product SpecificationsList of general specifications SpecificationList of supported signals RGB signals SpecificationsPin assignment of Computer in & Monitor terminals List of supported signals Y/PB/PR signalsList of supported signals Video, S-Video signals Control terminal Pin assignmentOthers
Top Page Image Contents