Toshiba TDP-T9 owner manual Placement Styles, Floor-mounted front projection

Page 22

Placement

Placement Styles

As shown in the ﬁgures below, this device can be placed in 4 different styles.

The factory setting is “ﬂoor-mounted front projection.” Set the [Projection mode] in the Default setting menu p.36 , in accordance with your needs.

Floor-mounted front projection

Floor-mounted rear projection

Ceiling-mounted front projection

Ceiling-mounted rear projection

WARNING

•Always obey the instructions listed in IMPORTANT SAFETY INSTRUCTIONS when placing the unit. Attempting to clean/replace the lamp at a high site by yourself may cause you to drop down, thus resulting in injury.

•If you wish to mount the projector on the ceiling, be sure to ask your dealer to do so. Mounting the projector on a ceiling requires special ceiling brackets (sold separately) and specialized knowledge. Improper mounting could cause the projector to fall, resulting in an accident.

•If the projector is ceiling-mounted, install the breaker for turning off the power in case of anomaly. Let everyone involved with the use of the projector know that fact.

22

Image 22

Contents Data Projector TDP-T9 Safety Precautions USA onlyBefore Using Power Sources Ventilation Important Safety InstructionsSource of Light Heat Power-Cord ProtectionCleaning Water and MoistureObject and Liquid Entry Lightning stormsDo not place the product vertically Stack InhibitedDamage Requiring Service AccessoriesServicing Safety Check Important Safety InstructionsReplacement Parts Do not use the product in a closed installation statePlace and Manner of Installation Power Supply Cord SelectionImportant Precautions Save Original Packing MaterialsExemption Clauses Important PrecautionsAvoid Volatile Liquid Disposal Other Cautions and InformationsCopyrights TrademarksRemote Control Batteries Contents Page Checking the package contents Names of each part on the main unit Names of each part on the control panel and remote control Label locations Parts on the rear panel Operating the remote control Preparing and using the remote controlLoading dry-cell batteries Into the remote control  Remove the battery cover  Insert the dry-cell batteriesConnecting a computer Operating a computerPlacement Styles PlacementFloor-mounted front projection Projection Distance and Size Screen As seen from above As seen from the sideConnection Before connectionTurning the power on and off Turning the power on Press the ON/STANDBY buttonTurning the power off Press the ON/STANDBY button Press the ON/STANDBY button againBasic operations Turn on the powerSelect the language When using the ﬁrst time Activate the connected device To adjust the horizontal angle, use Tilt adjuster Projector placement angle adjustmentsAdjusting the screen size and focus To stow the foot adjuster, hold up the projectorPress the remote control’s Auto SET button Using handy featuresUsing auto setting Only for analog input from computer Correcting the keystone distortionFreezing the image Freeze Password functionCutting off the picture and sound temporarily Mute Key LockIf you forgot the password, please inquire your dealer Using handy featuresRe-enter the same password for conﬁrmation Using the menus How to use the menusImage adjustment menu Detailed description Screen size Display setting menuBackground Detailed description Fan mode Using the menusDefault setting menu Lamp powerDisplaying Information Status display B/P RWhen the lamp is broken Lamp replacementAbout lamp Lamp replacement Reset the lamp timer Used LampsLens cleaning Lens and main unit cleaningMain unit cleaning Trouble indications No powerPower went out during use Lamp went out during use, or won’t come onBefore calling service personnel Separately sold product SpeciﬁcationsList of general speciﬁcations SpeciﬁcationList of supported signals RGB signals SpeciﬁcationsList of supported signals Video, S-Video signals List of supported signals Y/PB/PR signalsPin assignment of Computer in & Monitor terminals Control terminal Pin assignmentOthers