Toshiba RAS-10SAX, RAS-10SA-E service manual Part Replacement, Indoor Unit RAS-10SK-E, RAS-10SKX

			10. PART REPLACEMENT
10-1. Indoor Unit (RAS-10SK-E, RAS-10SKX)
No.	Part name		Procedure	Remarks
• Front panel		1) After stopping the operation of the air conditioner, be
			sure to turn off the circuit breaker or disconnect the
			power plug from the AC wall socket.
		2)	Open the screw caps and remove the two screws
			fixing the front panel.
		3)	Close the screw caps as they were.
		4)	Open the horizontal louver right below by your
			finger.
		5)	Open the lower side of front panel until it touches
			the horizontal louver, and remove it from the indoor
			unit by turning it.
			<To assemble the front panel>
		1)	Fix the two screws to secure the front panel.
		2)	Close the screw caps as they were.
		3)	Press four places where are the center, right end,
			left end and lower portions of	the air outlet.
		4)	Check the gap between the front panel and the main
			unit.
			If cooling or drying operation is performed without
			pressing the center of the air outlet, the surface of
			the front panel may be covered with frost and have
			a waterdrop.
‚ Electrical part		1) Perform the process • above.
	assembly	2) Remove the screw securing the shield metal plate.
		3)	Remove the electrical part cover by pressing the nail
			located on upper portion of the electrical part cover.
		4)	Remove the drain guide.
		5)	Remove the screw securing to the end plate of the
			heat exchanger.
		6)	Remove the connector (5p) for the fan motor and
			the connector (6p) for the louver motor from the
			microcomputer assembly.
		7)	After unhooking the electrical part base by pressing
			the fixing nail located on its lower portion, draw the
			electrical part base out toward you to remove it from
			the main unit.
		8)	Pull the TC sensor out from the holder of the heat
			exchanger.
		9)	Dress the connecting cable securely as shown in the
			right illustration.
			(Improper dressing will cause water leakage.)
ƒ Drain-pan		1) Perform the process ‚ above.
	assembly	2) Remove the drain-pan by pressing the four hooks
			downwards.
			(Keep it with the drain hose.)

– 48 –