Toshiba RAS-10SK-E Troubleshooting Flowcharts, Power can not be Turned on No Operation at All

9-3. Troubleshooting Flowcharts

9-3-1. Power can not be Turned on (No Operation at All)

<Preliminary checks>

(1)Is the supply voltage normal?

(2)Is the connection to the AC output OK.?

Shut off the power supply from AC outlet once and turn it on after 5 seconds.

NO Does the OPERATION lamp flash?

YES

Operation

Check Items

Main cause

Countermeasure

Symptom

Does the power turn	NO	Does the transmission	NO
on by pushing the		indicator of remote
[START/STOP] button		control flash normally and
of the remote control?		transmit certainly?

			YES	YES
			(No problem)
	Does the fuse	YES	Parts (R21, R109, SG01,
			C15, C01, DB01, C02,
	(F01) blow?
			IC01, T01) are defective.
	NO
	Does the thermal	YES	Wrong wiring of
	fuse blow?		AC cord or connecting
	(Under PF. Terminal)		cable is defective.
	NO
NO	Is the indication voltage
	(DC12V or 5V) of main
	PC board correct?
	YES
				PC board
				is defective.

Is the voltage		NO	Refer to the paragraph
across C02 measured			"Pre-check", or defective circuit
DC310V~340V?			before power PC board block.
	YES
			Shut off the power
Is the secondary				Is the secondary		SW transformer
voltage of SW trans-		NO	supply once, and turn	voltage of SW	NO
						(T01) or IC (IC01)
former (T01) measured			it on again after dis-	transformer measured		for power supply
DC35V, DC12V,			connecting the motor	DC35V, DC12V,
						is defective.
and DC7V ?			connector CN10*.	and DC7V?
	YES			YES

Remote control is defective.

Replace the remote control.

Replace the thermal fuse set. Check connection.

Replace the main PC board.

Replace the main PC board.

Motor is defective.

*Be sure to disconnect the motor connector CN10 after shut off the power supply, or it will be a cause of damage of the motor.

– 38 –