No. | Part name |
| Procedure | Remarks |
„ Horizontal grille | 1) Perform the process ‚. |
| ||
| Note: | 2) Remove the screw fixing the louver motor, and |
| |
| The horizontal |
| remove the louver motor. |
|
| grille can not be | 3) Remove the shaft of the horizontal grille from the |
| |
| removed without |
|
| |
| removing the |
|
|
|
| louver motor. |
|
|
|
… Heat exchanger | 1) Perform the process ƒ. |
| ||
|
| 2) | Remove the pipe holder from the rear side of main |
|
|
|
| unit by removing the screw. |
|
|
| 3) | Unhook the hooks fixing the left side of the heat |
|
|
|
| exchanger and remove the screw fixing it, then |
|
|
|
| remove the right side of the end plate from the rib |
|
|
|
| fixing the main unit by sliding the heat exchanger |
|
|
|
| slightly to the right side. |
|
† Cross flow fan | 1) Perform the process ƒ. |
| ||
|
| 2) | Loosen the set screw of the cross flow fan. |
|
|
| 3) | Remove the screw fixing the shaft bearing base. |
|
|
| 4) | Lift slightly up the left side of the heat exchanger, |
|
|
|
| and pull the shaft bearing base out left downwards. |
|
|
| When assembling it, fix it with the set screw on the |
| |
|
| position where the gap between the rear plate surface |
| |
|
| and the left end surface of the cross flow fan is 6 ~ |
| |
|
| 7mm. |
| |
‡ Shaft bearing | 1) Perform the process † above. |
| ||
|
| 2) | Remove the shaft bearing from the shaft bearing base. |
|
|
|
| <Caution for assembling> |
|
|
| • If a part of the shaft bearing is protruded from the |
| |
|
|
| housing, assemble it after pushing its portion into |
|
|
|
| the correct position in the housing. |
|
ˆ Fan motor | 1) Perform the process … above. |
| ||
|
| 2) | Perform the process |
|
|
| 3) | Remove the left and right motor bands. |
|
|
| 4) | Remove the fan motor after pulling the cross flow |
|
|
|
| fan out sliding it left and right. |
|
|
|
| – 49 – |
|
