Toshiba RAS-10SKX Wiring Connection, How to remove the front cabinet, How to open the screw cap

8-4-3. Wiring Connection

WARNING

To plug the cable in the plug receptacle, take the following precaution.

THIS APPLIANCE MUST BE EARTHED.

IMPORTANT

THE WIRES IN THIS MAINS LEAD ARE COLORED IN ACCORDANCE WITH THE FOLLOWING CODE:

L : Brown	-LIVE	L
N : Blue	-NEUTRAL	N
: Green and Yellow	-EARTH

Fig. 8-4-5

As the colors of the flexible cord of this appliance may not correspond with the colored markings, to identify terminals in your plug, as follows:

Connect BROWN colored core to plug terminal marked letter "L".

Connect BLUE colored core to plug terminal marked letter "N".

Connect GREEN AND YELLOW colored core to plug terminal marked Earth Symbol " ".

<How to remove the front cabinet>

4

			4
1	2	3	1	2

Vertical air flow louver.

Fig. 8-4-6

How to open the screw cap

•Place your finger on the lower part and push up to open the screw cap.

(1)Open the screw caps and remove the two screws securing the front cabinet.

(2)Close the screw caps as behind.

(3)Open the vertical airflow louver horizontally by hand.

(4)Slightly open the lower part of the front cabinet then pull the upper part of the front cabinet toward you to remove it from the rear plate.

Taking out the power cord

Slitted portion

•Cut off the slitted portion in the side face of the rear panel to take out the power cord. After this, remove burrs, sharp edges, etc., to smooth the cut face.

<How to connect the power cord>

For the air conditioner that has no power cord, connect a power cord to it as mentioned below.

•After removing the front cabinet, remove the terminal cover and the cord clamp.

•Connect and secure the power supply cord and secure the cord clamp and the terminal cover.

•Cut the rear panel following the cutting mark and put the power supply cord through the notch.

•Be sure to smooth out the notch with a file, etc.

Terminal block	Cord clamp
Power supply	Terminal cover
cord	Screw
L
N
	Screw
Earth line
	Screw

Fig. 8-4-7

<Stripping length of power cord>

30mm

10mm

L

N

10mm		Earth line
	40mm

NOTE :

•Use standard wire only.

•Wire type: More than H05-RN-F

Fig. 8-4-8

– 24 –