Toshiba RAS-10SKX Self-diagnosis by check codes, Operating key Indication after operation

<Self-diagnosis by check codes>

1)The self-diagnosis by the check codes is con- ducted under the block displays of item B-H in Table 9-2-1.

2)Remote control key operation under the ser- vice mode is conducted by ON/OFF or TEMP. The remote control display by each key op- eration is varied as shown below. Two digit number is displayed in a hexadecimal num- ber.

3)The self-diagnosis by the check codes is con- ducted with procedures shown below.

a)Enter the service mode and make sure the off timer display of the remote control shows

“ ” .

b)Operate the “ON/OFF” key and make sure the timer lamp on the display section is flashing (5 Hz).

c)At the same time, also make sure the op- eration lamp is also flashing. This shows that the protection circuit on the indoor PC board is working.

d)Operate the TEMP. key and make sure the remote control display shows “ ” and

flashing of the operation lamp. If the op- eration lamp is flashing, it shows the pro- tection circuits for connecting cable is work- ing or thermal fuse is blown.

e)In the same way, operate the TEMP. key so that the display is increased one by one to continue checks by the self-di- agnosis as shown in the next table. From

“ ” up to “ ” check operations of protection circuits for each block, and

“” to “ ” check operations of the typical protection circuits.

Table 9-2-3

Operating key Indication after operation

ON/OFF		“	”
		1 is added to data before operation.		“	”	“	”
TEMP.	(Up)				➞
		(Example)
		1 is subtracted from data before operation.		“	”	“	”
TEMP.	(Down)				➞
		(Example)
		10 is subtracted from data before operation.		“	”	“	”
“AUTO” LOUVER					➞
		(Example)
		Data before operation is directly transferred.		“	”	“	”
“SET” LOUVER					➞
		(Example)

– 36 –