Toshiba TLP780E owner manual Displaying Information, Press Call

Displaying Information

CONTENTS 41

Remote control

INPUTON/STANDBY

	LASER
KEYSTONE	AUTO	SET

L-CLICKR-CLICK

VOLUME/ADJUST

MENU ENTER EXIT

Information on the input signal source, etc., can be displayed.

CALL		Press CALL.
		The information described below is displayed.
		The information display turns off when the CALL button is
		pressed again.
	Status display
Input			- current input source
H-resolution			- the horizontal resolution of the input signal (at RGB input)
V-resolution			- the vertical resolution of the input signal (at RGB input)
H-frequency			- the horizontal frequency of the input signal (at RGB input)
V-frequency			- the vertical frequency of the input signal (at RGB input)
Sync			- the polarity of the sync signal (at RGB input)
Video mode			- the color mode of the video signal (at Video, S-Video input)
Signal format- the formatting of the Y/PB/PR signal (at Y/PB/PR input)
Lamp time			- the elapsed usage time of the lamp
Version			- the version of the firmware
Shutter			- the shutter speed of the document imaging camera (at
			document imaging camera input)

Operations

CALL

PIP FREEZE

RESIZE

CALL MUTE

Notes

•The information displayed is not refreshed even if it changes. To refresh the information, turn off the information display, then turn it back on.

•The information display turns off if any other operation is performed.

•The “Lamp time” shows an approximate time for lamp replacement. (It should not be used as a lamp warranty time counter.) If the time indicated here nears 1000, contact your store of purchase about obtaining a replacement lamp (TLPL78, sold separately).

•The “Lamp time” can be reset when the lamp is replaced.

•The “Version” is the version of the control program used in the projector and is used for servicing, etc.