Toshiba GN-1060 manual Select the transmit power and press Next button

Page 41

1 SETTING UP WIRELESS NETWORK

Selecting no security mode

You can also set no security for wireless access.

If you do not set no security, anyone knows how the SSID can connect to the wireless network. Therefore, it is recommended to set the security if it is possible.

1 Press [NONE] and press [NEXT].

The TRANSMIT POWER SETTINGS screen is displayed.

2 Select the transmit power and press [NEXT] button.

Select the low transmit power if you want to limit the area that the wireless communication is enabled. If you do not have to limit the area, select [100%].

3 Confirm the settings and press [FINISH] button.

If you want to change the settings, press [PREV] to move back to the screen that you want to change and then repeat the operation.

Setting up the Ad Hoc Mode 39

Image 41

Contents Operators Manual for Wireless LAN Module Page Preface „ How to read this manual ‰ Symbols in this manual‰ Model and series names in this manual ‰ Options‰ Trademarks „ Precautions for Use Precautions„ About Toshiba Wireless Solution ‰ Wireless Interoperability‰ Canada Industry Canada IC ‰ Regulatory Information‰ Europe EU Declaration of Conformity EN 300Labelling ‰ USA-Federal Communications Commission FCC„ Notes ‰ Regulatory Notice for Channel Use in FranceContents Contents Setting Up the Infrastructure Mode Before Setting Up Wireless NetworkSetting up the Ad Hoc Mode Disabling Wireless Network„ Planning for installation Before Setting Up Wireless NetworkInfrastructure Mode Ad Hoc ModeWPA/WPA2/802.1X ‰ Determine the security mode‰ Determine the Ssid WEP Press Password Setting Up the Infrastructure ModeEnter the administrator password and press OK „ Select network typePress on and press Next Press Wireless SettingSetting Up the Infrastructure Mode Press Available Network „ Specify Ssid‰ Selecting the Ssid from the available network list Press Ssid ‰ Entering the Ssid manuallyScreen returns to the Ssid Settings screen Press EAP-TLS and press Next „ Select security modePress WPA, WPA2 or 802.1X, and then Next Press Next Press Disable and press EAP User NameEncryption Between AP and STA Specify the following items and press NextPress YES, and wait until the setting is reflected Confirm the settings and press FinishPress Peap and press Next ‰ Selecting WPA/WPA2/802.1X security mode with Peap protocolEAP User Name Enter the following items and press NextConfirm the settings and press Finish Press Wpapsk or WPA2PSK and press Next ‰ Selecting WPAPSK/WPA2PSK security modeSpecify the following items and press Next Press WEP button and press Next ‰ Selecting WEP security modeSpecify the following items and press Next Press None and press Next ‰ Selecting no security modePress YES, and wait until the setting is reflected Setting up the Ad Hoc Mode Wireless Setting screen is displayed Press AD HOC and press Next „ Specify Ssid Wireless LAN Security Settings screen is displayed Press WEP and press Next Select the transmit power and press Next Confirm the settings and press Finish button Select the transmit power and press Next buttonPress YES, and wait until the setting is reflected Press Password button Disabling Wireless NetworkPress OFF and press Next Appendix Specification Troubleshooting GlossaryDescription SpecificationWhen Cannot Connect to Toshiba MFP TroubleshootingWhen Error Messages are Displayed Glossary Numerics IndexIndex GN-1060 OME100082C0 GN-1060