Toshiba GN-1010 manual Configuration Screen

Configuration

This function sets the basic parameters such as the operating mode as well as the wire- less parameters.

Configuration Screen

1

2

8

	3		4	5	6	7
1.	Access Point	Selects the desired access point.
2.	Configuration Tab	Configuration menus are organized into each tab.
		•	“SNMP” and “Spanning Tree” tabs are not used.
3.	[Password]	Changes the password for the selected device.
		•	Up to 6 alphanumerics can be entered and is case-sen-
			sitive.
		• To change the password, enter the current password
			and new one.
		•	To make the new password effective, the reboot opera-
			tion is required.
4.	[Read]	Reads the configuration for the selected device.
5.	[Write]	Writes the currently displayed configuration to the selected
		device.
		•	To make the configuration effective, the reboot operation
			is required.
6.	[Default]	Restores the factory default setting.
		•	To apply the setting, write the configuration to the device
			and reboot it.
7.	[Reboot]	Reboots the selected device.
8.	[Exit]	Returns to the main menu.

•Password enrty is required for [Password], [Read], [Write], [Reboot] commands. The factory default setting has no password. In this case, you need not enter any- thing.

•Executing the command “[File] - [Save]” can save the currently displayed configura- tion on the hard disk and “[File] - [Open]” can load a previously saved file.

26 GN-1010 User’s Manual — Functions of the Utility Software