Toshiba GN-1010 manual Protocol Filter List File, Prtflist

Permits all the IP protocols

Permits all the TCP (Port 0 to 65535) Permits all the UDP (Port 0 to 65535)

# First Line Not omissible

# Not omissible (Enabled/Disabled) Permits #ARP

Permits #ICMP

Permits #DNS (UDP, Port 53)

Permits #HTTP (TCP, Port 80) Permits #FTP-DATA (TCP, Port 20) Permits #FTP (TCP, Port 21) Permits #SMTP (TCP, Port 25) Permits #POP3 (TCP, Port 110) Permits #Notes (TCP, Port 1352)

— Protocol Filter List File

Reading the list file previously prepared allows you to register protocols in “Protocol List” in one operation.

<Regarding Protocol Filter List File>

•File Name

PRTFLIST

•Size Specification

•512byte or below/Line (including space, comment, code regarding line feed)

•65,536byte (64Kbyte) or below/File (Approx. 1200 lines when each line con- tains 51byte)

•Restriction

•You must enter the line feed command at the end of each line.

•Protocols registered after the number reaches 256 are all ignored.

•Comment

•Characters following the "#" are considered as comment.

•When entering comment after the setting contents, you must enter one or more spaces between the contents and "#".

•Line Format to specify Protocol

•Specified by range

ProtocolType=(Ethernet Type),(IP Protocol),

(Start Pot Number),(End Port Number)

•Specified individually

ProtocolType=(Ethernet Type),(IP Protocol),(Port Number)

•Special Format

ProtocolType=IP,, ←

ProtocolType=IP,TCP, ←

ProtocolType=IP,UDP, ←

<Example of PRTFLIST>

[Protocol Filter Table]

ProtocolFilter=Enabled

ProtocolType=ARP,,

ProtocolType=IP,ICMP,

ProtocolType=IP,UDP,53

ProtocolType=IP,TCP,80

ProtocolType=IP,TCP,20

ProtocolType=IP,TCP,21

ProtocolType=IP,TCP,25

ProtocolType=IP,TCP,110

ProtocolType=IP,TCP,1352

For entry number, 1 is assinged to the first line of the protocol specifying lines, then the next lines 2, 3,... are successively assigned.

GN-1010 User’s Manual — Functions of the Utility Software 37