Toshiba GN-1010 manual Node Registration

Page 21

Node Registration

The first time you use the GN-1010, you must perform the “Node Registration”, which automatically detects and registers the GN-1010.

Once the “Node Registration” detects the GN-1010 installed on the network, its informa- tion will be stored in a file. Therefore, it is not required to perform “Node Registration” each time you start the utility.

1.Launch the utility software.

2.Click [Node Registration] from the main menu.

3.Click [Search] to detect an access point.

MAC address and IP address for each access point detected are dis- played in the Access Point List.

4.From the list, double-click an access point of which the name is registered.

When an access point cannot be detected, close the utility software. Then, launch it again to detect it.

Furthermore, if the access point cannot be detected after repeating the steps above, see the section "Troubleshooting" (P.52).

20

GN-1010 User’s Manual — Using the Utility Software

Image 21
Contents Operators Manual Precautions for USE Handling PrecautionsAbout Toshiba Wireless Solution Wireless LAN Adapter TypesWireless Interoperability Wireless LAN AdaptersWireless LAN and your Health Safety Instruction for Wireless ProductsUsage Restrictions Limitation of LiabilityPage Regulatory Information Canada Industry Canada ICEurope EU Declaration of Conformity ΜΕ ΤΗΝ Παρουσαtoshiba TEC ∆ΗΛΩΝΕΙ ΟΤΙ FX-DS110-APL GN-1010 USA-Federal Communications Commission FCCPrecautions Related to Service Product Configuration Before Using ProductConfiguration List CD-ROMIntroduction FeaturesTable of Contents Troubleshooting Functions of the Utility SoftwareAppendix Overview Component LocationsLED Power LED IndicatorsWRX LinkDIP Switches DIP Switch Default Setting Factory SettingFunction of DIP Switch AP2 Multi-channel OperationInfrastructure Wi-Fi Mode Operating ModeAccess Point AP Station STPage Connecting between the GN-1010 and PC Using the Utility SoftwareConnection with Cross Cable Connection with HubPreparing the Utility Software Node Registration Click Exit to complete the detection Enter the access point name and click OKConfiguration Click the appropriate tab and edit the parameters Click Read to load the setting of the device Click OKMain Menu Screen Functions of the Utility SOFT- WareNected to the same network group Configuration Screen Base ANY ID ESS IDWireless WSLWEP Classifi Parameter Default Description AP2 Extended RoamingRssi Extension Speed ControlMAC FilterMAC Address Filter Logflist MAC Address Filter List FileProtocol Filter Prtflist Protocol Filter List FileGN-1010 User’s Manual Functions of the Utility Software Registered information is displayed on the MAC Address List GN-1010 User’s Manual Functions of the Utility Software Registered information is displayed on the Protocol List Spanning Tree SnmpFile Management Common Items StatusEnvironment MTU InterfacesParameter Description Rssi Wireless NodeBridge Information of this tab is excluded from support Wireless Counter When Communication Fails TroubleshootingCheck Peripheral Environment or Installation Location Check SoftwareCheck Power LED When Device Does Not StartExternal Dimensions Product SpecificationsPhysical Specifications AppendixInput/Output Interface Software SpecificationGlossary Channel Spectrum Diffusion TransmissionBridge RouterPage Page Page Kanda NISHIKI-CHO, CHIYODA-KU, TOKYO, 101-8442, Japan GN-1010