Toshiba B-670-QQ, B-680-QQ owner manual Loading the Media

Page 20

8. LOADING THE MEDIA

EO1-33015

8. LOADING THE MEDIA

Strip type:

1Strip labels from the backing paper for about 200-mm long from the top edge of the label roll.

2Lower the backing paper release bar.

3Pass the backing paper between the strip roller and the backing paper holder. After taking up any slack of the media, set the backing paper release bar in position.

Media (Backing Paper)

Backing Paper Release Bar

Backing Paper Holder

Fig. 8-8

9.Turn the head lever to the proper position depending on the used media. (Refer to Fig. 7-1) 1: Labels or thin tag paper

2: Thick tag paper

CAUTION: When using labels ensure that the head lever is set to position 1.

10. Close the top and right side covers.

8-5

Image 20

Contents 670/680-QQ Series Energy Star is a U.S. registered mark Safety Summary Meanings of Each SymbolPrecautions Request Regarding MaintenanceTable of Contents Accessories IntroductionApplicable Model 7 2 T S 1 0 Q QSpecifications PrinterMSI, ITF, NW-7, CODE39, CODE93, CODE128 RM4SCC Royal Mail 4STATE Cutomer CodeOptions Media RibbonOverview FRONT/REAR ViewOperation Panel Front ViewDIP Switch Functions B-672 only DIP SWSET UP Procedure Setting UP the PrinterRequirements for Operation Interface CablesHolder Stand Installation Installing the PrinterConnecting the Power Cord and Cables Loading the Ribbon Head Lever PositionStep Do not Move the Media Guides using the screw Loading the MediaLoading the Media Setting the feed gap sensor position An easy way to set the black mark sensor positionCutter Module Media Outlet Loading the Media Inserting the Optional Flash Memory Card B-672 only Inserting the Optional Pcmcia Card B-682 only CARE/HANDLING of the Media and Ribbon General Maintenance CleaningWhite Screw Stud Ribbon End Sensor Plate Pinch Roller Lever Under the Media Guides Covers and PanelsRemoving Jammed Media Cleaning the Cutter Unit Cleaning the strip unitThreshold Setting Threshold setting procedureTroubleshooting Error Message Problem SolutionHead Error Ribbon ErrorCutter Error ErrorProblem Solution