Toshiba

A.2 Once the option is set to the desired level, press and hold the Function Control button. This will save the new load shed level setting. The UPS will indicate that the value has been stored by blinking the LEDs. After blinking the LED for a short time the UPS will exit the programming mode and return to bypass operation. To return the system to normal operation switch the RUN/STOP switch back to the RUN position.

B.Output Enable/Disable After Input Overvoltage Backup. Press the function control button. The unit is now ready to change the output enable/disable after input overvoltage backup option. This is indicated by the 150% LED turning on. This setting determines whether the UPS will go to bypass in the case of an input overvoltage fault. To change this setting press and hold the function control button.

B.1 This setting is set to disable output at the factory. Pressing the function control button causes the 100% LED to light, indicating output has been enabled. Pressing it again will change it back to disabled and the 100% LED will go off.

B.2 Once the option is set as desired, press and hold the function control button to save the setting. The UPS will indicate the setting has been saved by blinking the LED(s). The LED(s) will continue to blink for a short time after which the UPS will exit programming mode and return to bypass operation. To return the system to normal operation switch the RUN/STOP switch back to the RUN position.

C.Reset Battery Installed Date. This should be done whenever a new battery pack is installed. Press the function control button. The unit is now ready to reset the battery installed date. This is indicated by the Battery LED turning on. Once this mode has been entered press and hold the function control button to reset the battery install date to the current date. The UPS will indicate that the date has been reset by blinking the Battery LED for a short time after which the UPS will return to bypass operation. To return the system to normal operation switch the RUN/STOP switch back to the RUN position.

Note: It is not necessary that the unit’s internal clock be set to the correct date. The UPS will track time relative to the battery installation date. If it is desired to set the date, this can be done through remote communication. For instructions on performing this operation refer to either the "UPSmart" or "Remote Eye II" manual depending on the type of remote communication being used.