Toshiba 1000 Series manual System Configuration

Page 27

2.2 System Configuration

The UPS device and the internal backup battery make up the system. Depending on the site and load requirements of the installation, available options may be utilized to create a tailored solution.

Planning a UPS system should include the following considerations:

•The total demand of the protected system shall dictate the output power rating (VA). Allow a margin for future expansion or calculation inaccuracies from measuring power requirements.

•Backup time needed will determine the battery size needed. If the load is less than the UPS nominal power rating then the actual backup time will be longer.

•The following options are available:

•External Battery Cabinets, and

•Connectivity options (Remote Contact, SNMP/WEB card).

The following UPS models are available.

	Model	Backup time Internal	Recharge time to 90%
	Model	batteries	capacity
		batteries	capacity
	UPS 1000VA	7 min	4 hours
	UPS 1200VA	6 min	4 hours

Additional External Battery Cabinets are available if more back-up time is needed.

5

Image 27

Contents Page Important Notice Uninterruptible Power Supply Table of Contents Manual’s Purpose and Scope Page EMC Statements FCC PartICES-003 Declaration of Conformity Request Safety Alert Symbol / Signal Words General Safety InstructionsPage Special Symbols Important Safety Instructions Qualified Personnel onlyQualified Personnel shall XII Important Safety Instructions contd XIV LA Sécurité Conserver CES Instructions Instructions Importantes ConcernantInspection/Storage/Disposal Disposal Storage MaintenanceInstallation Precautions Conductor Routing and Grounding Operating Precautions XXI System Description IntroductionGeneral Description Block diagramPage Diagnostic Tests Free Run ModeSystem Configuration Storage Environment InstallationVertical and Wall-mounted Installations with Accessories Rack-mounted Installation with Accessories Stacked UPS Installation with accessories Rear Panel Views 1000VA 1200VA Tower Rear Panel 1000VA Rack mount 1U Rear Panel 1000VA Rack mount 2U Rear Panel Connection to main supply and loads 1000 1200 VA Example of Installation of Plug & Play products Settings Options Default Remarks Front Panel SettingsBattery Test TEST? RS-232 Standard Interface Port Computer and Alarm ConnectionsLoad Segments EPO Port emergency power offUSB Port Network Transient ProtectorButton Operation User’s Guide to OperationsUPS Startup and Shutdown Starting the UPS Shutting Down the UPSON-LINE Control Panel functionsNormal Display UPS Meters DisplayLCD Message Description UPS Configurations Interpreting UPS Messages Audible AlarmsSilencing an Alarm UPS Manual TestTroubleshooting Maintenance Output Technical SpecificationsPower Range 1000-1200 VA LV General InputEnvironmental Power Range1000 VA 19 Rack-mount model, LV, 1U & 2U GeneralPower Range 1000-1200 VA HV General Standard Power Range 1000 VA 19 Rack-mount model, HV, 1U & 2U GeneralRack-mount HV Model Tower HV ModelRack-mount LV Model Tower LV ModelUninterruptible Power SUPPLIES-UPS Warranty InformationLimitations and Exclusions Page Respective warranty period will warranty work be performed Procedure for Defective Product Screening and DispositionModifications