Toshiba BDRV-WBX8-Z31 Version 7.2.4 M-3 manual Function Description Support

Function

Description

Support

	Driver Options tab	<Device Line Substitution>	{
		When enabled, the driver will try to use the printer's
		Line Commands to draw lines.
		When disabled, lines are drawn by using the
		Graphic Command.
		<Default Copies>	{
		Allows setting the number of copies to be printed as
		default. If the number of copies is not changed
		in the application, this value will be effective.
		<Disable Copies Limit>	X
		When enabled, a value exceeding “9999” can be
		set for the “Default Copies”.
		<Disable User-Defined Paper Size>	X
		When this checkbox is checked, the user-defined
		paper size “USER” cannot be used.
Graphics tab	Resolution	Shows the printer’s available resolution.	{
	Dithering	Allows creating the illusion of different shades of	{
		gray by varying the pattern of dots.
		<Color Adjustment>	{
		Allows the flip horizontal, flip vertical, rotation, color
		balance adjustment, etc.
		<Dithering Setup>	{
		Allows detailed setting for the selected dithering
		method.
	Color	<Color Control>	{
		Allows setting the color processing.
Stock	Media settings	<Print Method>	{
		Allows selecting whether the ribbon is used (thermal
		transfer) or not (Direct thermal).
		<Sensor>	{
		Allows selecting a sensor type used to detect a print
		start position.
		<Label Gap>	{
		Allows setting the length of the gap between labels.
	Issue Settings	<Issue Mode>	{
		Allows selecting whether the labels are issued in the
		strip mode.
		<Post-Print>	{
		Allows selecting whether the labels are issued in the
		cut mode. Note that the Pause is not supported.
		<Occurrence>	{
		Allows selecting the cutter operation and specifying
		how often labels should be cut.
		<Interval>	{
		Specifies the number of labels to be printed before a
		cut operation. The cutter will cut labels after the
		specified number of labels is printed.
		<Print Speed>	{
		Allows setting the print speed.
	Fine Adjustment	<Feed>	{
		Specifies the length of label that will feed after	{
		printing.
		<Backfeed>	{
		Specifies the length of label stock that is retracted
		before printing. This entry window is only available
		in cut or strip mode.
		<Cut/Strip>	{
		For the cut issue, specifies the length of label to feed
		before cutting the label.
		For the strip issue, specifies the length of label to
		feed before peeling the label.
		- 51 -