Toshiba BDRV-WBX8-Z31 Version 7.2.4 M-3 manual „ Supply Options, „ Ribbon Adjustments

„Supply Options

Allows setting the printing energy for each of the “Direct thermal” and “Thermal transfer”. When “Use Current Print Setting” is selected, the printer operates according to the currently selected setting.

Selection of “Direct thermal” or “Thermal transfer” depends on which is selected for the “Print Method“ on the Stock page.

„Ribbon Adjustments

When the thermal transfer method is selected, setting the conditions related to the ribbon is allowed.

() 3.4.2 Ribbon Adjustments.)

„Multiple Part Print Area Settings

Enables setting the duplicate print area on double-layer thermal paper. This feature is available only to the B-419 and B-EV4-G. For the B-EV4-G, “Variable Speed A” or “Variable Speed B” specified for the “Print Speed” on the Stock page is reflected in the printer behavior.

3.4.1Multiple Part Print Area Settings (B-419 and B-EV4-G only)

Clicking the “Multiple Part Print Area Settings” button on the Options page enables setting the duplicate print area properties for the double-layer thermal paper.

„Multiple Part Print Area

When the “Set” checkbox is checked, you can specify the details of the “Multiple Part Print Area”.

The “Multiple Part Print Area” is the area where the printer prints both sheets of the double-layered thermal paper at the same time by applying the higher print energy.

When not checked, the printer operates according to its current settings.

•Multiple Part Print Area

Enables setting the “Multiple Part Print Area Offset (a)” (X-coordinate of the multiple part print area start position) and “Multiple Part Print Area Length (b)”. The print on the specified area will become darker than the normal print areas.

• Multiple Part Print Area Offset: 0.0mm to 390.0 mm

• Multiple Part Print Area Length: 0.0mm to 390.0 mm

- 68 -