Toshiba BDRV-WBX8-Z31 Version 7.2.4 M-3 manual Configuration for the Status Monitor, Interface

Be sure to set the [Printer Status Monitoring] as shown in the table below. The status monitor has been disabled as default. Wrong setting disables proper printing.

Configuration for the Status Monitor

When the [Printer Status Monitoring] is set to other than “Disabled”, it is possible to monitor the printer status from the host computer. When this feature is not supported or is unnecessary, choose the “Disabled” for the [Printer Status Monitoring]. Doing so reduces the load on the printer driver and increases the print efficiency.

					: Any setting	X: Disabled
			Interface
	RS-232C *1	Parallel (Printer cable) *2		USB	LAN／WLAN
	(Serial interface	Conforming to IEEE1284
					10BASE-T／100BASE-TX
	cable)	(Compatible/ECP mode)
Conditions	―	Other than the right	CENTRO.MODE=ECP	Ver1.1/2.0	Standard TCP/IP		Other Port
Printer model		column	PLUG&PLAY =ON		Port（RAW）
B-SX6T-R		X	Not supported				X
B-SX8T-R
B-EX4T1-G		X	Not supported				X
B-EX4T1-T
B-EX4T2-G
B-EX4T2-T		X	Not supported				X
B-EX4T2-H
B-EV4-G	X	X	Not supported	X	X		X
B-EV4-T	X	X	Not supported	X	X		X
B-EP2DL-G		Not supported	Not supported				X
B-EP4DL-G	Not supported	Not supported	Not supported				X
B-452-R		X	Not supported				X
B-852-R		X	Not supported				X
B-SA4G, B-SA4G-CN,		X	Not supported				X
B-SA4T, B-SA4T-CN
B-SX4, B-SX4-CN		X	○				X
B-SX5, B-SX5-CN
B-SV4		X	Not supported		Not supported		Not
							supported
B-372	X	X	Not supported	Not	X		X
				supported
B-472	X	X	Not supported	Not	X		X
B-472-CN				supported
B-572	X	X	Not supported	Not	Not supported		Not
				supported			supported
B-672	X	X	Not supported	Not	X		X
B-872				supported
B-682	X	X	Not supported	Not	X		X
B-882				supported
B-415	X	Not supported	Not supported	Not	Not supported		Not
				supported			supported
B-419	X	Not supported	Not supported	X	Not supported		Not
							supported
B-431	X	Not supported	Not supported	Not	Not supported		Not
				supported			supported
B-452, B-452H	X	X	Not supported	Not	X		X
				supported
B-482	X	X	Not supported	Not	X		X
				supported
B-492	X	X	Not supported	Not	X		X
				supported
B-852	X	X	Not supported	Not	X		X
				supported
B-SP2D	X	Not supported	Not supported	Not	X		X
				supported
CB-416-T3	X	X	Not supported	Not	Not supported		Not
CB-426-T3				supported			supported

Notes:

1.When RS-232C (Serial interface) is used for connection, it will take time until printing starts. It is recommended to use other interfaces as far as possible.

-6 -