Dell 3000 manual Cards, Notch Memory module Cutouts Crossbar

9Align the notch on the bottom of the module with the crossbar in the connector.

notch

memory module

cutouts (2)

crossbar

NOTICE: To avoid breaking the memory module, do not press near the middle of the module.

10Insert the module straight down into the connector, ensuring that it fits into the vertical guides at each end of the connector. Press firmly on the ends of the module until it snaps into place.

If you insert the module correctly, the securing clips snap into the cutouts at each end of the module.

11Replace the computer cover (see page 75).

NOTICE: To connect a network cable, first plug the cable into the network wall jack and then plug it into the computer.

12Connect your computer and devices to electrical outlets, and then turn them on.

13Click the Start button, right-click My Computer, and then click Properties.

14Click the General tab.

15To verify that the memory is installed correctly, check the amount of memory (RAM) listed.

Cards

CAUTION: Before you begin any of the procedures in this section, follow the safety instructions located in the Product Information Guide.

56

Removing and Installing Parts