ProSafe Dual Band Wireless Access Point WAG102 Reference Manual (802.11a/g)
3.From the Country/Region
Note: If your country or region is not listed, please check with your local government agency.
4.Enter the IP Address fields of the WAG102.
–DHCP Client. By default, the Dynamic Host Configuration Protocol (DHCP) client is disabled. If you have a DHCP server on your LAN and you enable DHCP, the wireless access point will get its IP address, subnet mask and default gateway settings automatically from the DHCP server on your network when you connect the WAG102 to your LAN.
–IP Address. Enter the IP Address of your wireless access point.The default IP address is 192.168.0.232. To change it, enter an unused IP address from the address range used on your LAN; or enable DHCP.
–IP Subnet Mask. The Access Point will automatically calculate the subnet mask based on the IP address that you assign. Otherwise, you can use 255.255.255.0 (the default) as the subnet mask.
–Default Gateway. Enter the IP address of the gateway for your LAN. For more complex networks, enter the address of the router for the network segment to which the wireless access point is connected. The default is 0.0.0.0.
–Primary DNS Servers. The WAG102 will use this IP address as the primary Domain Name Server used by stations on your LAN. The default is 0.0.0.0.
–Secondary DNS Servers. The WAG102 will use this IP address as the secondary Domain Name Server used by stations on your LAN. The default is 0.0.0.0.
5.Enable 802.1Q VLAN. If enabled, each security profile will be associated with the default VLAN for WAG102. (Useful primarily if the hubs/switches on your LAN support the VLAN 802.1Q standard.) The default is Disabled.
6.From the
Basic Installation and Configuration |