NETGEAR WAG102NA manual Verify the following parameters for all access points

ProSafe Dual Band Wireless Access Point WAG102 Reference Manual (802.11a/g)

•Configure the WAG102 (AP3) in Repeater mode with the Parent AP MAC Address of AP2.

Wireless PC

Associated with AP1

Wireless PC

Associated with AP3

Wireless PC

Associated with AP2

Figure

3.Verify the following parameters for all access points:

•Verify that the LAN network configuration the WAG102 Wireless Access Points are configured to operate in the same LAN network address range as the LAN devices.

•All access points must be on the same LAN. That is, all the LAN IP addresses of the access points must be in the same network.

•If using DHCP, all WAG102 Wireless Access Points should be set to “Obtain an IP address automatically (DHCP Client)” in the IP Address Source portion of the Basic IP Settings menu.

•All WAG102 Wireless Access Points use the same SSID, Channel, authentication mode, if any, and encryption in use.

4.Verify connectivity across the LANs.

A computer on any LAN segment should be able to connect to the Internet or share files and printers with any other PCs or servers connected to any of the three WLAN segments.

4-8 Advanced Configuration

v2.0, September 2006