NETGEAR WAG102NA manual Configuring a Point-to

ProSafe Dual Band Wireless AccessManual (802.11a/g)

Configuring a Point-to-

To configure a point-to-multi-point
1. Under Advanced on the maim	or Advanced
Access Point Settings 11b/g. The	.

Figure 4-5
2. Configure the Operating Mode
• WAG102 (AP1) on LAN	MAC
Address of AP2.
• Because it is in the central	Segment 2 in
Point-to-Multi-Point Bridge	APs are required
in AP2.
• Configure the WAG102 (AP3) on LAN	mode with the Remote
MAC Address of AP2.

3.Verify the following parameters for all access points:

•Verify that the LAN network configuration the WAG102 Wireless Access Points are configured to operate in the same LAN network address range as the LAN devices

•Only one access point is configured in Point-to-Multi-Point Bridge mode, and all the others are in Point-to-Point Bridge mode.

•All access points must be on the same LAN. That is, all the APs LAN IP address must be in the same network.

4-6 Advanced Configuration

v2.0, September 2006