NETGEAR 54 Mbps Wireless Access Point WG602v4 Reference Manual
When the wireless access point is connected to the Internet, you can click the KnowledgeBase link or the Documentation link under the Web Support menu to view support information or the documentation for the wireless access point.
Note: Unless you click Logout, the wireless access point will log you out after 5 minutes of no activity.
5.From the Setup menu on the left panel, select IP Settings. The IP Settings screen will display.
Figure
The wireless access point is shipped preconfigured to act as a DHCP client. Verify the default settings (suitable for most users):
•Access Point Name. This is the name of your wireless access point.You may modify the default name with a unique name up to 15 characters long. The default name is netgearxxxxxx, where xxxxxxx represents the last 6 digits of the WG602v4 MAC address.
•DHCP Client: Enabled so that your wireless access point will get its TCP/IP configuration from the DHCP server on your network.
•Spanning Tree Protocol. By default Spanning Tree Protocol is enabled. This provides network traffic optimization in configurations with multiple Wireless APs.
You may manually configure the IP settings for the WG602v4 by checking the Disable radio box for DHCP Client. The default IP configuration will display:
•IP Address: 192.168.0.227
Installation and Configuration |