NETGEAR WG602V4 manual V1.0, June

NETGEAR 54 Mbps Wireless Access Point WG602v4 Reference Manual

•IP Subnet Mask: 255.255.255.0

•Gateway: 0.0.0.0

If your network has a requirement to use a different IP addressing scheme, you can make those changes on this screen.

6.Click Apply to save any changes.

.

Note: If you change the default subnet of the LAN IP address, you will be disconnected from the Wireless AP user interface. To reconnect, reconfigure your computer with a static IP address within the new LAN IP subnet.

To configure your basic wireless settings:

1.From under the Setup menu, select Wireless Settings. The Wireless Settings screen will display.

Figure 2-5

2.Enter or modify the wireless settings appropriate to your network:

•Wireless Network Name (SSID). The SSID is the wireless network name. Enter a value of up to 32 alphanumeric characters; the characters are case sensitive. In a setting where more than one wireless network is present, using a different wireless network name allows your to separate the traffic. Any device you want to participate in a particular wireless network needs to use the SSID. The default SSID is: NETGEAR.

•SSID Broadcast. If SSID Broadcast is disabled, only devices that have the correct SSID can connect. The default is Enable.

2-6 Installation and Configuration

v1.0, June 2007