NETGEAR 54 Mbps Wireless Access Point WG602v4 Reference Manual
This screen displays the following parameters:
Table 3-1. General Information Fields
Field | Description | |
|
|
|
Access Point Information |
| |
|
|
|
| Access Point Mode | Shows the current operating mode of the device: AP, Bridge, |
|
| Repeater or Client. |
|
|
|
| Access Point Name | The default name can be changed if desired. |
|
|
|
| MAC Address | Displays the Media Access Control address (MAC Addresses) of the |
|
| wireless access point’s Ethernet port. |
|
|
|
| Region | Displays the country or region for which the wireless access point is |
|
| licensed for use. It may not be legal to operate this wireless access |
|
| point in a region other than one of those identified in this field. |
|
|
|
| Firmware Version | The version of the firmware currently installed. |
|
|
|
Current IP Settings – These parameters apply to the Local WG602v4 wireless access point. | ||
|
|
|
| IP Address | The IP address of the wireless access point. |
|
|
|
| Subnet Mask | The subnet mask for the wireless access point. |
|
|
|
| Default Gateway | The default gateway for the wireless access point. |
|
|
|
| DHCP Client | Enabled by default. Enabled (DHCP client) indicates that the current |
|
| IP address was obtained from a DHCP server on your network. |
Wireless Settings – These parameters apply to the target remote WG602v4, VPN gateway, or VPN client.
| Wireless Network Name (SSID) | Displays the wireless network name (SSID) being used by the |
|
| wireless port of the wireless access point. The default is NETGEAR. |
|
|
|
| Associated AP (Client mode | The MAC address of a remote AP or peer that this wireless access |
| only) | point is connected to. |
|
|
|
| Channel | Identifies the channel the wireless port is using. |
|
|
|
| Encryption Type | The current encryption setting. |
|
|
|
| Access Control | Restricts wireless access by MAC address. Disabled by default. |
|
|
|
Viewing a List of Attached Devices
The Station List table contains a list of all devices associated with this wireless access point in the wireless network defined by their Wireless Network Name (SSID). The feature is not available when in Client Mode.
Management |