APC AP9607 manual Multiple SmartSlot Installation

Page 18

Multiple SmartSlot Installation continued

Installation in For installation of multiple SmartSlot devices in the Sym-

the Symmetra metra PowerArray, refer to the numbering shown in the

PowerArray figure that follows. Note that the PowerNet SNMP Adapter is installed in slot #4, Call-UPSII in #3, the Interface Expander in #2, and Measure-UPSII in #1.

If you are using an external SmartSlot housing (Expansion Chassis or Triple Chassis) in conjunction with a Symmetra Power Array, install the devices with higher priority in the external slot(s). Refer to “Installation in the APC Triple Chassis” on page 13, if applicable.

Daisy chains If you have increased your SmartSlot capacity by daisy- chaining Expansion Chassis or Triple Chassis, install the PowerNet SNMP Adapter (or Web/SNMP Management Card) and Call-UPSII in the highest-numbered and second- highest-numbered slots, respectively, of the chassis installed farthest from the UPS.

14

Image 18

Contents Interface Expander Thank You Contents Connection procedure Connecting the Interface Expander Introduction On next Hardware Software Requirements By the Interface Expander. When ordering a cable, provide Part NumberProduct Description Status Description Simple Signaling Smart Signaling Key ConceptsCommunication Types PowerChute plus PowerChute plus, configured for smart signaling, to moniUPS can provide simple signaling, we strongly recommend Expander use simple signaling with PowerChute orReboot of the system Signaling. Use either one of these proceduresUPS and continue with the installation, including Run PowerChute plus and connect to the UPSExpander generates a Low Battery signal under certain Interface Expander generates a Low Battery signalLess of whether the UPS is on battery. The Interface Other conditions according to the configured shutdownKey Concepts Multiple SmartSlot Installation Multiple SmartSlot Installation Multiple SmartSlot Installation Installation Slot until the front panel is flush with the back Orient the Interface Expander to fit the accessorySlot. Slide the Interface Expander all the way into Panel of the UPS or deviceConnecting to Protected Devices Described in Connection procedure on Configuring the Interface Expander PowerChute plus installation directory. To find out Some versions of PowerChute plus do not support ConFirmed shutdown mode when set up for simple signaling Whether your version of PowerChute plus supports ConUPS battery is exhausted, shutting down the UPS after If power returns before any connected server has signaledUPS before all connected servers have signaled shut Low Battery Signal Time has elapsedInterface Expander detects a UPS Low Battery condition, it Expander allows the UPS to run on battery until utilityPower is restored, or until the battery is exhausted. If Equal to the Low Battery Signal Time and then shuts downTesting Interface Expander Warranty Information Exclusion of implied warranties therefore, the aforesaid Claims by third parties, or otherwise. This warranty givesPurpose. Some jurisdictions do not permit limitation or Specifically, APC is not liable for any costs, such as lostTroubleshooting Problem Possible Cause Solution Persists, follow this procedure For problems not covered in the troubleshooting chart seeTroubleshooting on page 26, or if the problem Lem. a technician will help solve the problem overLife-Support Policy Specifications Assignments Specification Interface ExpanderIndex Index Y, Z Page Conformity is Application of CounCil Directives Standards to Which DeclaredW. a p c c . c o m