APC AP9607 manual Y, Z

Page 39

Index continued

Switches, configuration DIP,

5

Until Low Battery shutdown

behavior, 19

 

mode, 22

Symmetra PowerArray, installation

UPS Interface Extension Cable, 4

of SmartSlot devices in,

14

UPS shutdown modes, 19

T, U, V

 

 

W, X, Y, Z

 

Temperature

 

 

Warning, 15

 

 

safety warning, 4

 

Warranty

 

 

Testing the Interface Expander, 23

limitations,

25

 

Timer shutdown mode, 22

statement,

24

 

Triple Chassis

 

 

Warranty Information,

24– 25

daisy chaining with,

14

Web/SNMP Management Card,

installation of multiple SmartSlot

priority in multiple SmartSlot

devices in, 13

 

device installation, 12

Troubleshooting,

26–

28

Windows server cable, 4

table, 26– 27

 

 

 

 

Wiring, safety warning,

4

Unix server cable,

4

 

 

 

 

 

35

Page 38 Page 40
Image 39
Page 38 Page 40
Contents Interface Expander Thank You Contents Connection procedure Connecting the Interface Expander Introduction On next Hardware Software Requirements Part Number By the Interface Expander. When ordering a cable, provideProduct Description Status Description Simple Signaling Smart Signaling Key ConceptsCommunication Types Expander use simple signaling with PowerChute or PowerChute plus, configured for smart signaling, to moniUPS can provide simple signaling, we strongly recommend PowerChute plusRun PowerChute plus and connect to the UPS Signaling. Use either one of these proceduresUPS and continue with the installation, including Reboot of the systemOther conditions according to the configured shutdown Interface Expander generates a Low Battery signalLess of whether the UPS is on battery. The Interface Expander generates a Low Battery signal under certainKey Concepts Multiple SmartSlot Installation Multiple SmartSlot Installation Multiple SmartSlot Installation Installation Panel of the UPS or device Orient the Interface Expander to fit the accessorySlot. Slide the Interface Expander all the way into Slot until the front panel is flush with the backConnecting to Protected Devices Described in Connection procedure on Configuring the Interface Expander Whether your version of PowerChute plus supports Con Some versions of PowerChute plus do not support ConFirmed shutdown mode when set up for simple signaling PowerChute plus installation directory. To find outLow Battery Signal Time has elapsed If power returns before any connected server has signaledUPS before all connected servers have signaled shut UPS battery is exhausted, shutting down the UPS afterEqual to the Low Battery Signal Time and then shuts down Expander allows the UPS to run on battery until utilityPower is restored, or until the battery is exhausted. If Interface Expander detects a UPS Low Battery condition, itTesting Interface Expander Warranty Information Specifically, APC is not liable for any costs, such as lost Claims by third parties, or otherwise. This warranty givesPurpose. Some jurisdictions do not permit limitation or Exclusion of implied warranties therefore, the aforesaidTroubleshooting Problem Possible Cause Solution Lem. a technician will help solve the problem over For problems not covered in the troubleshooting chart seeTroubleshooting on page 26, or if the problem Persists, follow this procedureLife-Support Policy Specifications Assignments Interface Expander SpecificationIndex Index Y, Z Page Declared Application of CounCil Directives Standards to Which Conformity isW. a p c c . c o m
Top Page Image Contents