Epson GT-5500 manual Removing the Transportation Screw

Page 15

Removing the Transportation Screw

Before connecting the scanner to a power source, you must remove the transportation screw.

1.Place the scanner on a flat, stable surface with its rear panel facing you.

2.Remove the screw located in the middle of the rear panel by turning it counter-clockwise, as shown below. If necessary, turn the screw with a coin or screwdriver to loosen it.

SCSI	*	0	1
	7		2
	6	5	4 3
		5	4 3

SCSI

ON

SW

3.Push the screw into the storage hole marked STOCK. It does not screw in. Make sure you push it all the way into the hole.

SCSI	*	1
		0
7		2

63

5 4

SCSI

ON

SW

Note:

Do not discard the transportation screw. It must be replaced when storing or transporting the scanner.

Setting Up the Scanner 1-3

Image 15

Contents Page Scanner Parts GT-5500 Declaration of Conformity Contents Appendix a Technical Specifications Glossary Index Page Features IntroductionOptions Important Safety Instructions Scsi System Cable 25-pin to 50-pin B860081Scsi Peripheral Cable 50-pin to 50-pin B860091 Introduction For United Kingdom Users Safety informationSetting Up the Scanner Choosing a Place for the Scanner Removing the Transportation Screw Plugging In the Scanner Initialization Connecting the Scanner to Your Computer Understanding Scsi connectionsDaisy Chain Scsi Cables Setting the Scsi ID numberPage Do not use an external terminator CCaution Connecting the scannerPower-on sequence For Windows 95 users Power-off sequenceUsing Your Scanner Lights and Buttons Lights Before scanning a document Placing a Document on the ScannerCorner of the document Do not place heavy objects on top of the scanner Removing the Cover for Thick or Large DocumentsRAM and hard disk size Sizing Up Your SystemFile compression software Accelerator boardsVideo cards MonitorsMaintenance and Troubleshooting Cleaning the scanner MaintenanceReplacing the fluorescent lamps Transporting the ScannerError indicators Problems and SolutionsScanner does not start scanning Operating problemsOperate light does not come on Ready light does not come onScanner software does not work properly Edges of the document are not scanned Quality problemsEntire image is distorted or blurred Part of the image is distorted or blurredImage does not look the same as the original Image is faint or out of focusImage is too dark Straight lines in the image are jaggedLine of dots is always missing in the scanned image Your image cannot be printed or the printout is garbled Printed image is larger or smaller than the original sizeTechnical Specifications Scanning 2Technical SpecificationsElectrical Environmental Safety ApprovalsScsi Interface Initialization Methods Contacting Customer Support Contacting Customer SupportEnquiry Desk For United Kingdom and the Republic of Ireland UsersCustomer Support Epson Faxback For Australian UsersFor Hong Kong Users For Singapore UsersElectronic bulletin board system For Philippines UsersAdditive primary colors GlossaryESC/I Scsi Threshold Index IN-1 IndexIN-2 Index Index IN-3 IN-4 Index Epson Overseas Marketing Locations Epson AMERICA, INC