Metrologic Instruments MS9500 manual Stand Option 2 Hard-mounted to countertop

Page 13

Assembling the Stand (continued)

Stand Option 2: Hard-mounted to countertop

2.00 in

2.00
#8 Wood	Anchor
#8 Wood
Screw
	Base

Step 1

Drill four #39 holes in the countertop.

Step 2

Secure the base (mlpn 36-36080) to the countertop with the four #8 wood screws (mlpn 18-18057) provided.

Step 3

Screw the anchor (mlpn 50-50449) onto the base until it sits flush.

Step 4

Remove the logo plate on the stand by gently using an exacto knife to release the plate hook.

Step 5

Position the stand over the base assembly.

Step 6

Secure the stand to the base assembly by tightening the set screw located under the logo plate.

Step 7

Snap the logo plate back into place.

8

Image 13

Contents Page USA Corporate Headquarters Europe LocationsIii Table of Contents Appendix B Appendix aAppendix C Appendix DVoyager Voyager CodeGate Interface Introduction∙ Installation and User’s Guide Mlpn Scanner and AccessoriesVoyager MS9540 CodeGate Single-Line Laser Scanner Quick Start Installing the Scanner to the Host System Disconnecting PowerLink Cables from the Scanner Two Modes of Operation How to Use CodeGate MS9540 OnlyKit #46-46055 Contains Assembling the StandStand Option 1 Self-supported Stand Option 2 Hard-mounted to countertop Scanner Parts Three Beeps On Power Up Audible IndicatorsOne Beep Razzberry ToneThis is a failure indicator. Refer to Failure Modes on Visual Indicators Steady Red, Green off Alternating Flashing of Green and RedFlashing Green and one Razzberry Tone Failure ModesHow does Serial Programming work? Programming ModesHost Scanner Feature Command Ascii Representation Response Abbreviated Ascii Table Upgrading the Flash Rom Firmware Avoid Exposure laser light emitted from this aperture LabelsDistance Depth of FieldScanner Face Width of Scan FieldIR Activation Maintenance Scanner Version Communication Protocols Identifier Applications and ProtocolsTrouble Shooting Guide Symptoms Possible Causes Solution Troubleshooting GuideTroubleshooting Guide Unit scans Receiving data but RS-232 Demonstration Program Operational Appendix a Design SpecificationsLight IBM KBW PEN Appendix B Default SettingsDTS/SIEMENS DTS/NIXDORF NCR F NCR S 46XX Light IBM Parameter Msec to Find Supplement Programmable Msec steps max Rdata Appendix CPin D-type female connector to the PC Function Cable Connector Configurations Standard PowerLink cablePowerLink Cable Pin Female DIN Pin Function Cable Connector ConfigurationPin Male Mini-DIN Pin Function Adapter Cable Pin Male DIN Pin FunctionLimited Warranty Appendix D Warranty and DisclaimerRemarque Appendix E NoticesAttenzione AchtungPatents Appendix FAddendum AddendumCdrh IndexRMA