Metrologic Instruments MS9500 manual Appendix B Default Settings, Light IBM KBW PEN

Page 36

Appendix B – Default Settings

Many functions of the scanner can be “programmed” – that is, enabled or disabled. The scanner is shipped from the factory programmed to a set of default conditions. The default parameter of the scanner has an asterisk (*) in the charts on the following pages. If an asterisk is not in the default column then the default setting is OFF or DISABLED. Every communication does not support every parameter. If the communication supports a parameter listed in the charts on the following pages, a check mark will appear.

	PARAMETER	DEFAULT	OCIA	RS-232	LIGHT	IBM	KBW
	PARAMETER	DEFAULT	OCIA	RS-232	PEN	46XX	KBW
					PEN	46XX
	Normal Scan Mode	*
	Continuous Scan Mode
	Blinky Scan
	Continuous Blinky Scan
	Custom (one shot) Scan
	Long-Range In-Stand	*
	Short-Range In-Stand
	Long-Range Out-of-Stand	*
	Short-Range Out-of-
	Stand
	CodeGate Active In-
	Stand
	CodeGate Inactive In-
	Stand	*
	CodeGate Active Out-of
	Stand	*
	CodeGate Inactive Out-of
	Stand
	UPC/EAN	*
	Code 128	*
	Code 93	*
	Codabar	*
	Interleaved 2 of 5 (ITF)	*
	MOD 10 check on ITF
	Code 11
	Code 39	*
	Full ASCII Code 39

31

Image 36

Contents Page Locations USA Corporate Headquarters EuropeIii Table of Contents Appendix a Appendix BAppendix C Appendix DIntroduction Voyager Voyager CodeGate InterfaceScanner and Accessories ∙ Installation and User’s Guide MlpnVoyager MS9540 CodeGate Single-Line Laser Scanner Quick Start Installing the Scanner to the Host System Disconnecting PowerLink Cables from the Scanner How to Use CodeGate MS9540 Only Two Modes of OperationAssembling the Stand Kit #46-46055 ContainsStand Option 1 Self-supported Stand Option 2 Hard-mounted to countertop Scanner Parts Audible Indicators Three Beeps On Power UpOne Beep Razzberry ToneThis is a failure indicator. Refer to Failure Modes on Visual Indicators Alternating Flashing of Green and Red Steady Red, Green offFailure Modes Flashing Green and one Razzberry ToneProgramming Modes How does Serial Programming work?Host Scanner Feature Command Ascii Representation Response Abbreviated Ascii Table Upgrading the Flash Rom Firmware Labels Avoid Exposure laser light emitted from this apertureDepth of Field DistanceScanner Face Width of Scan FieldIR Activation Maintenance Applications and Protocols Scanner Version Communication Protocols IdentifierTrouble Shooting Guide Troubleshooting Guide Symptoms Possible Causes SolutionTroubleshooting Guide Unit scans Receiving data but RS-232 Demonstration Program Appendix a Design Specifications OperationalAppendix B Default Settings Light IBM KBW PENDTS/SIEMENS DTS/NIXDORF NCR F NCR S 46XX Light IBM Parameter Msec to Find Supplement Programmable Msec steps max Appendix C RdataCable Connector Configurations Standard PowerLink cable Pin D-type female connector to the PC FunctionCable Connector Configuration PowerLink Cable Pin Female DIN Pin FunctionPin Male Mini-DIN Pin Function Adapter Cable Pin Male DIN Pin FunctionAppendix D Warranty and Disclaimer Limited WarrantyAppendix E Notices RemarqueAchtung AttenzioneAppendix F PatentsAddendum AddendumIndex CdrhRMA