Metrologic Instruments MS9500 manual Audible Indicators, One Beep, Razzberry Tone

Audible Indicators

When the Voyager is in operation, it provides audible feedback. These sounds indicate the status of the scanner. Eight settings are available for the tone of the beep (normal, 6 alternate tones and no tone). To change the tone, refer to the MetroSelect Programming Guide MLPN 2407.

￿	One Beep
	When the scanner first receives power, the green
	LED will turn on, then the red LED will flash and the
	scanner will beep once. (The red LED will remain on
	for the duration of the beep.) The scanner is ready to
	scan.
	When the scanner successfully reads a bar code, the
	red LED will flash and the scanner beeps once (if
	programmed to do so). If the scanner does not beep
	once and the green light does not flash, then the bar
	code has not been successfully read.

	Razzberry Tone
	This tone is a failure indicator. Refer to
	“Failure Modes"page 13.
￿￿￿	Three Beeps - During Operation
	When entering configuration mode, the red LED will
	flash while the scanner simultaneously beeps three
	times. The red and green LEDs will continue to flash
	while in this mode. Upon exiting configuration mode,
	the scanner will beep three times, and the LEDs will
	stop flashing.
	When configured, 3 beeps can also indicate a
	communications timeout during normal scanning
	mode.
	When using one-code-programming, the scanner will
	beep three times (the current selected tone), followed
	by a short pause then by a high tone and a low tone.
	This tells the user that the single configuration bar
	code has successfully configured the scanner.
￿￿￿	Three Beeps - On Power Up

10