Metrologic Instruments MS9500 manual Visual Indicators

Page 17

Visual Indicators

There are three LED indicators (green, red and yellow) located on the head of the MS9500. When the scanner is on, the flashing or stationary activity of the LEDs indicates the status of the current scan and the scanner.

Green, Red & Yellow LEDs are off

The LEDs will not be illuminated if the scanner is not receiving power from the host or transformer.

The scanner is stand-by mode, and CodeGate is enabled. Present a bar code to the scanner and the green LED will turn on when the laser turns on.

Steady Yellow

The CodeGate button is not active. If a bar code is in the scan field, the laser will turn on. The bar code will be decoded and transmitted to the host automatically.

Steady Green

When the laser is active, the green LED is illuminated. The green LED will remain illuminated until the laser is deactivated.

Steady Green and Single Red Flash

When the scanner successfully reads a bar code, the red LED will flash and the scanner will beep once. If the red LED does not flash or the scanner does not beep once, then the bar code has not been successfully read.

Steady Green and Steady Red

After a successful scan, the scanner transmits the data to the host device. Some communication modes require that the host inform the scanner when data is ready to be received. If the host is not ready to accept the information, the scanner’s red LED will remain on until the data can be transmitted.

12

Image 17

Contents Page USA Corporate Headquarters Europe LocationsIii Table of Contents Appendix B Appendix aAppendix C Appendix DVoyager Voyager CodeGate Interface IntroductionVoyager MS9540 CodeGate Single-Line Laser Scanner Scanner and Accessories∙ Installation and User’s Guide Mlpn Quick Start Installing the Scanner to the Host System Disconnecting PowerLink Cables from the Scanner Two Modes of Operation How to Use CodeGate MS9540 OnlyStand Option 1 Self-supported Assembling the StandKit #46-46055 Contains Stand Option 2 Hard-mounted to countertop Scanner Parts Three Beeps On Power Up Audible IndicatorsOne Beep Razzberry ToneThis is a failure indicator. Refer to Failure Modes on Visual Indicators Steady Red, Green off Alternating Flashing of Green and RedFlashing Green and one Razzberry Tone Failure ModesHow does Serial Programming work? Programming ModesHost Scanner Feature Command Ascii Representation Response Abbreviated Ascii Table Upgrading the Flash Rom Firmware Avoid Exposure laser light emitted from this aperture LabelsDistance Depth of FieldScanner Face Width of Scan FieldIR Activation Maintenance Scanner Version Communication Protocols Identifier Applications and ProtocolsTrouble Shooting Guide Symptoms Possible Causes Solution Troubleshooting GuideTroubleshooting Guide Unit scans Receiving data but RS-232 Demonstration Program Operational Appendix a Design SpecificationsLight IBM KBW PEN Appendix B Default SettingsDTS/SIEMENS DTS/NIXDORF NCR F NCR S 46XX Light IBM Parameter Msec to Find Supplement Programmable Msec steps max Rdata Appendix CPin D-type female connector to the PC Function Cable Connector Configurations Standard PowerLink cablePowerLink Cable Pin Female DIN Pin Function Cable Connector ConfigurationPin Male Mini-DIN Pin Function Adapter Cable Pin Male DIN Pin FunctionLimited Warranty Appendix D Warranty and DisclaimerRemarque Appendix E NoticesAttenzione AchtungPatents Appendix FAddendum AddendumCdrh IndexRMA