Datalogic Scanning C-BOX 200 installation manual Opening the Device, Opening the C-BOX

DATALOGIC C-BOX 200

2.2 OPENING THE DEVICE

To install the C-BOX 200 or during normal maintenance, it is necessary to open it by unscrewing the four cover screws:

WARNING

The C-BOX 200 must be disconnected from the power supply during this operation.

Figure 2.2 - Opening the C-BOX 200

It is possible to perform the following operations:

•Proceed with the cable connections (see paragraph 2.4.2).

•Set the multiplexer address selection on the rotary switches.

•Mount the C-BOX 200 to a wall or panel.

Installation - 3