Datalogic Scanning C-BOX 200 installation manual Safety Precautions, Power Supply

Page 8

SAFETY PRECAUTIONS

POWER SUPPLY

ATTENTION: READ THIS INFORMATION BEFORE INSTALLING THE PRODUCT

- This product is intended to be installed by Qualified Personnel only.

The C-BOX 200 is intended to be supplied by an NEC Class 2 power source, rated 10-30 V, minimum 0.65 A.

See par. 2.4.1 for correct power supply connections.

vii

Image 8

Contents BOX Installation Manual BOX821000560 Contents Guide to Installation General View Figure aFigure B Safety Precautions Power SupplyViii General Features DescriptionInstallation Package ContentsOpening the Device Opening the C-BOXMechanical Installation Overall dimensionsMounting C-BOX Electrical Connections and Setup System layoutPower Supply Power switch ON/OFF positionsSystem Wiring System cable connectionsRefer to the scanner Installation Manual for details Chassis Grounding Jumper Settings Chassis grounding10 Rotary switches Multidrop Address Selection11 Termination resistance switch 5 RS485 Bus TerminationConnection to a Multiplexer BOX7 OM4000 Jumper Settings 13 OM4000 jumpers14 9-pin male connector Pin connector pinout Name Function 9-PIN Scanner Auxiliary Serial InterfaceScanner Requirements Operating Modes1 GET/SEND Buttons GET SendLED Indicators 15 LED IndicatorsTechnical Features Environmental Features