Datalogic Scanning C-BOX 200 Refer to the scanner Installation Manual for details

DATALOGIC C-BOX 200

The C-BOX 200 spring clamp connector pinouts are indicated in the following table.

Refer to the scanner Installation Manual for details.

Pin	Name
1, 3, 5	VS
2, 4, 6	GND
7, 8	EARTH GROUND
*9, 13	RS485 CABLE SHIELD
*10, 14	RS485 REF
*11, 15	RTX485+
*12, 16	RTX485-
20, 33, 34, 40	Reserved
21	OUT1+
23	OUT2+
27	EXT TRIG+
28	EXT TRIG-
35	TXA
37	RXA
39	SGND

	DS2100	DS4300
	DS2400	DS4600
22	OUT REF	OUT1-
24	OUT REF	OUT2-
25, 26	NC	Reserved
29	NC	IN1+
30	NC	IN1-
31	NC	IN2+
32	NC	IN2-
36	RTSA	GND
38	CTSA	SGND AUX

*The signals on pins 9, 10, 11 and 12 are repeated on pins 13, 14, 15 and 16 to facilitate network connections (i.e. Multiplexer connections using the RS485 half-duplex Interface). In this way the network bus can enter and exit the C-BOX from different spring clamps but be physically connected together.

NOTE

Pin 7 or 8 should be connected to the earth ground.

Pin 17, 18 and 19 are not present in the C-BOX 200 model.

Installation - 9