Datalogic Scanning C-BOX 200 installation manual PIN Scanner Auxiliary Serial Interface

Page 24

DATALOGIC

C-BOX 200

2.5 9-PIN SCANNER AUXILIARY SERIAL INTERFACE

The scanner auxiliary serial interface available on the internal 9-pin connector can be used either for configuration through WinHost or for data monitoring.

The details of the connector pins are indicated in the following table:

Figure 2.14 - 9-pin male connector

9-pin connector pinout

Pin	Name		Function
1			N.C.
2	RXA		Auxiliary RS232
3	TXA		Auxiliary RS232
4			N.C.
5	SGND		Signal Ground
6			N.C.
9			N.C.
		DS2100 - DS2400
7	CTSA		Auxiliary Handshake RS232
8	RTSA		Auxiliary Handshake RS232

		DS4300 - DS4600

7	SGND AUX		Auxiliary Signal Ground
8	GND		Ground

Installation - 15

Image 24

Contents BOX Installation Manual BOX821000560 Contents Guide to Installation General View Figure aFigure B Safety Precautions Power SupplyViii General Features DescriptionInstallation Package ContentsOpening the Device Opening the C-BOXMechanical Installation Overall dimensionsMounting C-BOX Electrical Connections and Setup System layoutPower Supply Power switch ON/OFF positionsSystem Wiring System cable connectionsRefer to the scanner Installation Manual for details Chassis Grounding Jumper Settings Chassis grounding10 Rotary switches Multidrop Address Selection11 Termination resistance switch 5 RS485 Bus TerminationConnection to a Multiplexer BOX7 OM4000 Jumper Settings 13 OM4000 jumpers14 9-pin male connector Pin connector pinout Name Function 9-PIN Scanner Auxiliary Serial InterfaceScanner Requirements Operating Modes1 GET/SEND Buttons GET SendLED Indicators 15 LED IndicatorsTechnical Features Environmental Features