Datalogic Scanning C-BOX 200 Chassis Grounding Jumper Settings, Chassis grounding

C-BOX 200 DATALOGIC

2.4.3 Chassis Grounding Jumper Settings

The scanner chassis grounding method can be selected by positioning a jumper (see Figure 2.9). In this way the scanner chassis can be connected to earth ground (only if pins 7 or 8 are connected to a good earth ground) or to the power supply ground signal. The scanner chassis can also be left floating but, in this case, the jumper must be removed.

to EARTH	to GND	floating
GROUND
(default)

Figure 2.9 – Chassis grounding

The C-BOX 200 is now installed which completes the electrical connections for your scanning system.

10 - Installation