Datalogic Scanning C-BOX 200 installation manual LED Indicators

Page 27

C-BOX 200

DATALOGIC

2.7.2 LED Indicators

Power on Warning

Tx

Figure 2.15 - LED Indicators

The three internal LEDs of the C-BOX 200 (see Figure 2.15) indicate the following:

POWER ON	(red) indicates the C-BOX 200 is connected to the power
	supply and the power switch is ON.
WARNING	(red) indicates a warning or error condition: it is ON when a
	connection procedure is in progress (the system is busy) or
	during a GET/SEND procedure. It blinks when an error
	condition occurs. Normally this LED should be OFF.
TX	(green) indicates the RS485 Multidrop activity. When
	communication takes place, this LED will blink slightly.

18 - Installation

Image 27

Contents BOX BOX Installation Manual821000560 Contents Guide to Installation Figure a General ViewFigure B Power Supply Safety PrecautionsViii Description General FeaturesPackage Contents InstallationOpening the C-BOX Opening the DeviceOverall dimensions Mechanical InstallationMounting C-BOX System layout Electrical Connections and SetupPower switch ON/OFF positions Power SupplySystem cable connections System WiringRefer to the scanner Installation Manual for details Chassis grounding Chassis Grounding Jumper SettingsMultidrop Address Selection 10 Rotary switches5 RS485 Bus Termination 11 Termination resistance switchBOX Connection to a Multiplexer13 OM4000 jumpers 7 OM4000 Jumper Settings9-PIN Scanner Auxiliary Serial Interface 14 9-pin male connector Pin connector pinout Name FunctionOperating Modes Scanner RequirementsGET Send 1 GET/SEND Buttons15 LED Indicators LED IndicatorsEnvironmental Features Technical Features