Barco R9840171, R9840170, R9840176 manual No Communication, ADDR=1

Menu Setup

Menu Setup

Remark concerning display images

The bold items do not appear bold on the screen. This is only done to grasp the attention of the reader.

Display layout

The two upper lines are a copy of the local LCD of the projector when in Remote Mode or the contents of the Lamp information module when in Lamp Read Mode.

In case of a 6000 series LCD projector these two lines are not displayed.

Line 1	NO COMMUNICATION
Line 2
Line 3
	ADDR=1	BAT=LOW/RF=LOW
Line 4
	PRESS <ADJUST> TO ENTER

The third line is in most case a status line, showing all kinds of status information of the Remote Control.

Different status messages:

ADDR=	displays the address of the remote (for example 1).
BAT=ACT	the remote is working on batteries, there is no supply via external power source.
BAT=LOW	the battery is running low (see "<Installation Setup" for charging procedure)
RF=ACT	the remote is working with wireless communication.
RF=LOW	the remote is working with wireless communication but has not etablished a good
	communication link.

INTERNAL TEMP TOO HIGH

The third line may also display the actual Internal Menu main title.

The fourth line is a command line, showing possible key commands.

It also displays the item of the Internal menu.

General Menu structure

The Rugged Remote Control's Internal Menu is accessible by pressing the <ADJ> button. Pressing twice <ADJ> gives access to the projector's Menu or exits the Menu.

Flowchart 1

MAIN SCREEN

ADJ

RRC INTERNAL MENU

ADJ

MAIN SCREEN

ADJ command not sent to projector

2nd ADJ command sent to projector

24