Menu Setup
Lamp Mode Menu
Access to the Lamp Read Mode Menu
1. Press <ADJ> to enter the Internal Menu (menu 1). | + |
2.Select INSTALLATION SETTINGS by browsing with -
3.Select OPERATION MODE by pressing <ENTER> (menu 2).
4.Select the Lamp Read Mode by pressing <ENTER>, menu 4 is displayed.
5.Exit the Internal Menu by pressing <EXIT> or <ADJ>.
NO COMMUNICATION | NO COMMUNICATION |
INSTALLATION SETTINGS | INSTALLATION SETTINGS |
CONT BRIG COLO TINT PHAS | OPERATION MODE |
menu 1 | menu 2 |
NO COMMUNICATION | LAMP |
| SERIAL NO: |
OPERATION MODE | OPERATION MODE |
OPER. MODE [REMOTE] | OPER. MODE [LAMP READ] |
menu 3 | menu 4 |
Browsing the Lamp Read Mode Menu
To browse the Lamp read Mode Menu when in menu 4 follow next procedure:
1.Browse the different parameters using the shown on line 2 (menu 4)
+buttons (see flowchart 1), the parameter is
-
LAMP READ MODE
+
-
flowchart 1
LAMP
line 2
BAT=ACT
PRESS <ADJUST> TO ENTER
menu 4
SERIAL NUMBER
ARTICLE NUMBER
RUN TIME
REMAINING RUN TIME
NUMBER OF STRIKES
32