Barco R9840176, R9840171, R9840170 manual Identification menu

Page 26

Menu Setup

Identification menu

IDENTIFICATION MENU

RUGGED REMOTE CONTROL

SOFT VERSION: --.--

OPER.MODE:--------

COMM.PORT: -------

BAUDRATE:---------

ADDRESS:----------

BATTERY CHARGING:--

browse with: +

Th identification Menu gives an overview of some parameters within the 'Installation Settings' Menu.

The parameters in the 'Identifcation' Menu are Read Only.

Operation Mode

OPERATION MODE

REMOTE	change(17(5with:
LAMP READ

The Operation Mode allows to switch between the two Modes:

-Remote Mode

-Lamp Read Mode

See Lamp Mode Menu (p.23) and Remote Mode Menu (p.24) for further detail.

26

Image 26

Contents Rugged Remote Control for ELM/SLM Projectors R9840170 R9840171 R9840176Page Contents Installation Instructions Safety InstructionsSafety Instructions Owners Record100-240VAC 0.4A 47-63 Hz Safety WarningOn Safety On servicing On installationSafety indication on the product Definition On cleaningOn repacking Accessories Rugged Remote ControlUpgrade Kits General InformationContents Specifications DescriptionDescription & Specififcations Charger Serial interface RS 232/422Description & Specififcations Keypad Exit EnterDescription & Specififcations Wireless Base Power Connections Installation setupInstallation Setup Installation Setup Power on switch Supplying the Wireless BaseInstallation Setup Charging the batteries No Communication ADDR=1 BAT=LOW Press Adjust to EnterNo Update Press ANY KEY to ExitInstallation Setup Changing the batteries Remote Mode Configuration SetupConfiguration Setup Configuration Setup Lamp Read Mode Configuration Setup RS232/422 Communication ASLQ*1DVVDGDSWHU*1$Configuration Setup Configuration Setup RF Mode Download is performed through the RS232 communication port No Communication ADDR=1Installation Settings Identification menu Communication Menu COMM.PORT Auto Baudrate XLR No Communication COM.PORT Auto BaudratePress Enter to browse No Communication Setting UP Communication RF OptionsPress Enter No Update Base Synchronised Press Exit to Continue Select Synchronize baseNo Communication Change Address How to change the address Select Change addressInstallation settings menu No Communication Lamp Operation Mode OPER. Mode Remote OPER. Mode Lamp ReadBAT=ACT Press Adjust to Enter Select Operation Mode by pressing Enter No Communication Operation Mode OPER. Mode RemoteMenu Setup Remote Mode Menu Communication COM.PORT XLRMessages Additionnal InformationAdditionnal Information Mechanical Information DimensionsMechanical Information Mechanical Information Barco NV / Projection Systems