Barco R9840176, R9840171 manual Description & Specififcations Charger, Serial interface RS 232/422

Page 11

Description & Specififcations

Charger

Input range : 100-240V (autoranging) 47-63Hz

400mA Output: 15V DC/1A

Input/Output Signals


image 3	A		B		CTRL 3		CTRL 4
Two Way	Hardwired Remote (CTRL 3)						Lamp Info Module (CTRL 4)
	'SLQ*1'DVVLJQHPHQW$7$						P US H

Fixed rate: 57600 baud
Cable type: XLR connection, twisted pair	Cable type: supplied

Serial interface RS 232/422

Serial interface A (image 3)

Selectable modes :

-RS 422 T: RS422 terminated.

-RS 422 NT: RS422 Not Terminated

-RS 232

Termination resistor = 120 Ohms

11

Image 11

Contents R9840170 R9840171 R9840176 Rugged Remote Control for ELM/SLM ProjectorsPage Contents Owners Record Safety InstructionsSafety Instructions Installation Instructions100-240VAC 0.4A 47-63 Hz Safety WarningOn Safety On servicing On installationSafety indication on the product Definition On cleaningOn repacking General Information Rugged Remote ControlUpgrade Kits AccessoriesContents Description SpecificationsSerial interface RS 232/422 Description & Specififcations ChargerExit Enter Description & Specififcations KeypadDescription & Specififcations Wireless Base Power Connections Installation setupInstallation Setup Supplying the Wireless Base Installation Setup Power on switchPress ANY KEY to Exit No Communication ADDR=1 BAT=LOW Press Adjust to EnterNo Update Installation Setup Charging the batteriesInstallation Setup Changing the batteries Remote Mode Configuration SetupConfiguration Setup Configuration Setup Lamp Read Mode ASLQ*1DVVDGDSWHU*1$ Configuration Setup RS232/422 CommunicationConfiguration Setup Configuration Setup RF Mode Download is performed through the RS232 communication port ADDR=1 No CommunicationInstallation Settings Identification menu Communication Menu COMM.PORT Auto Baudrate XLR Baudrate No Communication COM.PORT AutoPress Enter to browse No Communication Setting UP Communication RF OptionsPress Enter Select Synchronize base No Update Base Synchronised Press Exit to ContinueNo Communication Change Address How to change the address Select Change addressInstallation settings menu No Communication Lamp Operation Mode OPER. Mode Remote OPER. Mode Lamp ReadBAT=ACT Press Adjust to Enter Communication COM.PORT XLR No Communication Operation Mode OPER. Mode RemoteMenu Setup Remote Mode Menu Select Operation Mode by pressing EnterMessages Additionnal InformationAdditionnal Information Mechanical Information DimensionsMechanical Information Mechanical Information Barco NV / Projection Systems