Barco R9840170 No Communication Change Address, How to change the address Select Change address

Page 31

Menu Setup

Change Address

How to change the address:

1.Select 'Change address'

2. Press <ENTER>

+

3.Use numeric keys or -

4.Confirm with <ENTER>

in 'Installation settings' (menu 1).

to fill in the new address ( number between 1 and 255 )

NO COMMUNICATION

CHANGE ADDRESS

ADDRESS1

menu 1

Shortcut : Use the <ADDR> key for direct access to the address menu. (<ADDR> displays also the projector's address)

Diagnosis

Flowchart 1 gives an overview of the read only parameters within the 'Diagnosis menu'.

DIAGNOSIS
		XLR:ON/OFF
+	INPUT POWER PORT
		DC INPUT:ON/OFF
		VOLTAGE:OK/LOW
	BATTERY STATUS
	(17(5	CHARGING:ON/OFF
	INTERN.TEMP	TEMPERATURE: OK
		STATUS	+++
-		CONTROL	+++
-	I2C DIAGNOSIS
	I2C DIAGNOSIS

MEMORY +++

LAMP ++-

Flowchart 1

+

-

+

-

+

-

31

Image 31

Contents R9840170 R9840171 R9840176 Rugged Remote Control for ELM/SLM ProjectorsPage Contents Owners Record Safety InstructionsSafety Instructions Installation InstructionsOn Safety Safety Warning100-240VAC 0.4A 47-63 Hz Safety indication on the product On installationOn servicing On repacking On cleaningDefinition General Information Rugged Remote ControlUpgrade Kits AccessoriesContents Description SpecificationsSerial interface RS 232/422 Description & Specififcations ChargerExit Enter Description & Specififcations KeypadDescription & Specififcations Wireless Base Installation Setup Installation setupPower Connections Supplying the Wireless Base Installation Setup Power on switchPress ANY KEY to Exit No Communication ADDR=1 BAT=LOW Press Adjust to EnterNo Update Installation Setup Charging the batteriesInstallation Setup Changing the batteries Configuration Setup Configuration SetupRemote Mode Configuration Setup Lamp Read Mode ASLQ*1DVVDGDSWHU*1$ Configuration Setup RS232/422 CommunicationConfiguration Setup Configuration Setup RF Mode Download is performed through the RS232 communication port ADDR=1 No CommunicationInstallation Settings Identification menu Communication Menu COMM.PORT Auto Baudrate XLR Baudrate No Communication COM.PORT AutoPress Enter No Communication Setting UP Communication RF OptionsPress Enter to browse Select Synchronize base No Update Base Synchronised Press Exit to ContinueInstallation settings menu How to change the address Select Change addressNo Communication Change Address BAT=ACT Press Adjust to Enter Operation Mode OPER. Mode Remote OPER. Mode Lamp ReadNo Communication Lamp Communication COM.PORT XLR No Communication Operation Mode OPER. Mode RemoteMenu Setup Remote Mode Menu Select Operation Mode by pressing EnterAdditionnal Information Additionnal InformationMessages Mechanical Information DimensionsMechanical Information Mechanical Information Barco NV / Projection Systems